Abstract:This study offers a comprehensive ab initio analysis of the structural, electronic, and mechanical properties of the trigonal (R 3̅ ), tetragonal (P4mm) and cubic (Pm 3̅ m) phases of SnBO 3 (BTi, Zr, Hf) oxide perovskite compounds using various functionals namely GGA-PBE, PBE0, HSE06, and B3LYP. From formation energy calculation, trigonal symmetry has been found to be the most stable phase. In the structure optimization, B3LYP estimates the largest volume under trigonal and tetragonal symmetry. However, for the cubic system of SnBO 3 , SnTiO 3 possess the largest volume when using PBE-GGA, while B3LYP estimates the largest in SnZrO 3 and both PBE-GGA and B3LYP estimates the same magnitude in SnHfO 3 . When Ti atom is replaced with either Zr or Hf, a notable shift in the second oxygen atomic coordinate was observed in the tetragonal phase along the z-direction, which impacts the lattice parameters leading to an expansion along the a-axis but with contraction along the c-axis. Structural changes have been found to correspond with electronic transitions. While the electronic transition in SnTiO 3 takes place along X→Γ , the transitions in both SnZrO 3 and SnHfO 3 occurs along X→Z in k space. In the cubic system, SnTiO 3 showed an indirect X→Z transition, whereas SnZrO 3 and SnHfO 3 demonstrated a direct X→X transition. Density of states calculations have revealed that contribution from the B-site atom in the energy states around the conduction band edge is reduced as Ti atom is substituted with Zr atom and subsequently with Hf atom for all the crystal phases. Mechanical stability was consistent across all the compounds in all the calculations with various exchange-correlation functionals considered. Analysis of the mechanical parameters of the trigonal phase of SnBO 3 has deduced that only SnTiO 3 using hybrid functionals shows brittleness. While only SnHfO 3 consistently exhibited a ductile nature throughout the functionals considered in the tetragonal phase, all compounds in the cubic phase were ductile. Interestingly, while the bulk modulus increased sequentially from Ti to Zr and then to Hf when B site atom is substituted in tetragonal structures, SnTiO 3 emerged as the most robust system in the cubic phase. In the tetragonal system, when Ti atom in SnBO 3 is replaced with either Zr or Hf, the piezoelectric response exhibits massive increase associated with the change in atomic position of the second oxygen atom along the c-axis and the response is also predicted to be highest in SnHfO 3 .

First-Principles Calculation Of Lead-Free Perovskite Sntio3

First-principles Study of Elastic Properties in Perovskite PbTiO3

Ferroelectric Phase Transition of Perovskite SnTiO3 Based on the First Principles

A Comprehensive First-Principles Investigation of SnTiO3 Perovskite for Optoelectronic and Thermoelectric Applications

First-Principle Study of Strain-Driven Phase Transition in Incipient Ferroelectric Srtio3

First principle calculations of electronic, band structural, and optical properties of BixSr1-xTiO3 perovskite

Electronic structure, mechanical properties and optical properties of three cobalt-based double halide perovskites: A first principles study

First-Principles Investigations on Electronic Properties of Rutile TiO2:F and SnO2:F

High Performance Lead Free Ferroelectric ATiO3/SnTiO3 Superlattices

First-principles Lattice Dynamics and Thermodynamic Properties of Pre-Perovskite PbTiO3

Influence of intrinsic defects on the structure and dynamics of the mixed Pb–Sn perovskite: first-principles DFT and NAMD simulations

Polymorphic Phase Transition and Enhanced Piezoelectric Properties in (ba0.9ca0.1)(ti1−xsnx)o3 Lead-Free Ceramics

Trilinear coupling in lead-free halide superlattice CsSn I 3 / CsSi I 3 : A first-principles study

An ab initio study of electronic, mechanical, and piezoelectric properties of the trigonal, tetragonal and cubic phases of lead-free perovskite SnBO 3 (B = Ti, Zr, Hf)

A first principle study of the perovskite lanthanum aluminate

First Principles Study on Electronic Structure and Optical Property of O-doped Lead-Free Perovskite CsSnCl3

Electronic Structure and Stability of Lead-free Hybrid Halide Perovskites: A Density Functional Theory Study

First Principles Analysis of Crystal Structure, Electronic and Optical Properties of CsSnI3–xBrx Perovskite for Photoelectric Applications

Modulation of organic groups substitution on the polarization and piezoelectric properties of lead-free organic perovskite ferroelectrics via first principles study

First-principles study of electronic and optical properties of lead-free double perovskites Cs2NaBX6

First Principle Study of Cesium-based Lead-free Halide Double Perovskites