Abstract:The smart diesel program requires the engine electronic control unit to consider additional parameters, such as altitude and climatic conditions, in the mapping calibration process. A specially designed environmental simulation cabin, which can simulate environmental conditions at any longitude and dimension, would allow dynamometer testing to be performed indoors. Considering its high cost, a three-dimensional (3D) computational fluid dynamics (CFD) is needed to guide and/or complement experimental researches. As a result, the main objective of this study was to establish a 3D RANS model (i.e., reasonable computational cost and running time) that can provide in-cylinder details and predict the efficiency of a 6V150 diesel engine under varied operating conditions. A sector mesh approach was employed, considering only the compression, combustion, and expansion periods from intake valve closing to exhaust valve opening. The results indicated that the model simulated cylinder pressure agreed well with the experimental data, with relative errors of less than 6% during the primary compression, combustion, and expansion. Further, the model predicted heat release phasing was inconsistent with the experimental results, with absolute errors of less than one crank angle degree for peak pressure location, CA50, and ignition delay. In addition, the multidimensional model captured the effects of environmental pressure and temperature on spray formation (i.e., the dominant phenomenological event). Moreover, the model reasonably reproduced the effects of engine control variables on performance and emissions. All these observations demonstrated the validity of the selection and calibration of geometry, chemistry, and submodels including turbulence, spray, heat transfer, combustion, etc. Overall, the model was deemed capable of predicting combustion characteristics under extreme conditions, including high-temperature, high-cold, and high-altitude environments, which can facilitate the development of smart engines.

A Quasi-Dimensional Model for Hydrogen-Enriched Gasoline Engines with a New Laminar Flame Speed Expression

Development of a Quasi-dimensional Model for Predicting the Combustion Process of Hydrogen-enriched Gasoline Engines

A quasi-dimensional model for combustion performance prediction of an SI hydrogen-enriched methanol engine

Development and Validation of a Quasi-Dimensional Combustion Model for SI Engines Fuelled by HCNG with Variable Hydrogen Fractions

A Fractal-Based Quasi-Dimensional Combustion Model for SI Engines Fuelled by Hydrogen Enriched Compressed Natural Gas

Numerical Investigation On The Combustion Process In A Spark-Ignited Engine Fueled With Hydrogen-Gasoline Blends

Development and Validation of A Laminar Flame Speed Correlation for the Cfd Simulation of Hydrogen-Enriched Gasoline Engines

Modeling of Hydrogen Combustion from a 0D/1D Analysis to Complete 3D-CFD Engine Simulations

A Laminar Flame Speed Correlation of Hydrogen–methanol Blends Valid at Engine-Like Conditions

An Advanced High Dimensional Model Representation Approach for Internal Combustion Engine Modeling and Optimization

A Model for the Laminar Flame Speed of Binary Fuel Blends and Its Application to Methane/hydrogen Mixtures

Study of Laminar Burning Speed and Calibration Coefficients of Quasi-Dimensional Combustion Model for Hydrogen Enriched Compressed Natural Gas Fueled Internal Combustion Engine along with Exhaust Gas Recirculation

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

Numerical Investigation of the Effects of Hydrogen Enrichment on Combustion and Emissions Formation Processes in a Gasoline Rotary Engine

Three-Dimensional Computational Fluid Dynamics Modeling of the Combustion Process of a MAN L21/31 Marine Diesel Engine

A Laminar Burning Velocity Correlation for Combustion Simulation of Hydrogen-Enriched Ethanol Engines

Prediction of Pollutants Emissions and Performance of Direct Injection Diesel Engines with Quasi Dimensional Combustion Model

Laminar flame speed modeling of pre-vaporized jet fuel/hydrogen mixtures under engine conditions

Effect of Hydrogen Blending on the Combustion Performance of a Gasoline Direct Injection Engine

Experimental and Modeling Study of Performance and Emissions of SI Engine Fueled by Natural Gas–hydrogen Mixtures