Abstract:Precision drilling with picosecond laser has been advocated to significantly improve the quality of micro-holes with reduced recast layer thickness and almost no heat affected zone. However, a detailed comparison between nanosecond and picosecond laser drilling techniques has rarely been reported in previous research. In the present study, a series of micro-holes are manufactured on stainless steel 304 using a nanosecond and a picosecond laser drilling system, respectively. The quality of the micro-holes, e.g., recast layer, micro-crack, circularity, and conicity, etc, is evaluated by employing an optical microscope, an optical interferometer, and a scanning electron microscope. Additionally, the micro-structure of the samples between the edges of the micro-holes and the parent material is compared following etching treatment. The researching results show that a great amount of spattering material accumulated at the entrance ends of the nanosecond laser drilled micro-holes. The formation of a recast layer with a thickness of ∼25 μm is detected on the side walls, associated with initiation of micro-cracks. Tapering phenomenon is also observed and the circularity of the micro-holes is rather poor. With regard to the micro-holes drilled by picosecond laser, the entrance ends, the exit ends, and the side walls are quite smooth without accumulation of spattering material, formation of recast layer and micro-cracks. The circularity of the micro-holes is fairly good without observation of tapering phenomenon. Furthermore, there is no obvious difference as for the micro-structure between the edges of the micro-holes and the parent material. This study proposes a picosecond laser helical drilling technique which can be used for effective manufacturing of high quality micro-holes.

Ablation and morphological evolution of micro-holes in stainless steel with picosecond laser pulses

Wavelength Effect on Hole Shapes and Morphology Evolution During Ablation by Picosecond Laser Pulses

Investigations of morphological features of picosecond dual-wavelength laser ablation of stainless steel

Improving the efficiency of picosecond laser micromachining of stainless steel

Ablation enhancement by defocused irradiation assisted femtosecond laser fabrication of stainless alloy

An investigation on the hole quality during picosecond laser helical drilling of stainless steel 304

Evolution of Microstructures on Stainless Steel induced by Ultra-Short Laser Ablation

Investigation of Microhole Quality of Nickel-Based Single Crystal Superalloy Processed by Ultrafast Laser

Experimental Study on Geometric Precision of Microholes Drilling by Picosecond Laser

Picosecond Laser Trepan Drilling of Vertical Sidewalls Micro-Holes for 631 Stainless Steel

A Comparison in laser precision drilling of stainless steel 304 with nanosecond and picosecond laser pulses

Nanosecond Pulsed Laser Ablation on Stainless Steel − Combining Finite Element Modeling and Experimental Work

Microhole Drilling by Double Laser Pulses with Different Pulse Energies

Formation of Porous Structure with Subspot Size under the Irradiation of Picosecond Laser Pulses

Dual-path Micro-Holes Process for 0cr17ni7al Stainless Steel Thin Plate with Picosecond Laser

Numerical Simulation and Experimental Study on Picosecond Laser Ablation of Stainless Steel

Processing of Micro-Hole by Millisecond Laser and Post Processing of Recast Layer

Laser ablation of metals by femtosecond pulses: Theoretical and experimental study

Study on Recast Phenomenon in Processing of Micro-Hole with Millisecond Laser

Competitive Mechanism of Laser Energy and Pulses on Holes Ablation by Femtosecond Laser Percussion Drilling on AlN Ceramics

Theoretical Study of Morphology of Holes Drilled by a Double-pulsed Laser Train