Abstract:The growth of a plasma electrolytic oxide (PEO) coating on Al was widely considered as an ejection of molten alumina on the surface, induced by a localized breakdown of the solid coating. However, evidences presented here indicated no breakdown of the insulating coating in the PEO process, based on the X-ray diffraction, scanning electron microscopy, transmission electron microscopy and energy dispersive spectrometry investigations. There are abundant channels in the coating layer from surface to substrate. However, the SEM observes indicating that the channels in the outer layer with a low-density distribution and a micron-sized diameter, the channels extending into the internal layer with a high-density distribution and a nano-sized diameter. In addition, a continuous thin amorphous alumina layer (AAL) was found between coating and substrate. An intermediate state of the AAL before transition to crystalline, with unusually thick character (∼2.7μm), is reported for the first time, which presented a typical cross-sectional characteristic of the ionic migration processes. Based on these microstructure observations, a growth mechanism is proposed here to explain the structural features, in which the discharge ignited in the gas-filled channels passing through both the outer layer and the internal layer. The main voltage drop of applying the hole sample loaded on the AAL at a magnitude of ∼1V·nm-1 due to excellent conductivity of discharge plasmas in the channels. Under a high electrical field, the AAL was thickening, ultimately squeezing the coating expanding outward. Abundant moving micro-discharges and localized expansions could result in the growth of the whole coating.

Plasma electrolytic oxidation of an Al-Cu-Li alloy in alkaline aluminate electrolytes: A competition between growth and dissolution for the initial ultra-thin films

A Mechanism for the Growth of a Plasma Electrolytic Oxide Coating on Al

New findings on properties of plasma electrolytic oxidation Coatings from study of an Al-Cu-Li alloy

Growth mechanisms for initial stages of plasma electrolytic oxidation coating on Al

Growth Process of Plasma Electrolytic Oxidation Films Formed on Magnesium Alloy AZ91D in Silicate Solution

Key Factors Determining the Development of Two Morphologies of Plasma Electrolytic Coatings on an Al–Cu–Li Alloy in Aluminate Electrolytes

Effect of NaOH on plasma electrolytic oxidation of A356 aluminium alloy in moderately concentrated aluminate electrolyte

Effect of Na3AlF6 on the Structure and Mechanical Properties of Plasma Electrolytic Oxidation Coatings on 6061 Al Alloy

High Growth Rate, Wear Resistant Coatings on an Al–Cu–Li Alloy by Plasma Electrolytic Oxidation in Concentrated Aluminate Electrolytes

An Investigation about the Evolution of Microstructure and Composition Difference Between Two Interfaces of Plasma Electrolytic Oxidation Coatings on Al

An Investigation of Microstructure Evolution for Plasma Electrolytic Oxidation (PEO) Coated Al in an Alkaline Silicate Electrolyte

Characteristics of plasma electrolytic oxidation on cast aluminum-silicon alloy

Influence of electrolyte components on the microstructure and growth mechanism of plasma electrolytic oxidation coatings on 1060 aluminum alloy

Plasma Electrolytic Oxidation of AZ31 Magnesium Alloy in Aluminate-Tungstate Electrolytes and the Coating Formation Mechanism

Wear and Corrosion Resistance of Plasma Electrolytic Oxidation Coatings on 6061 Al Alloy in Electrolytes with Aluminate and Phosphate

In-situ Electrochemical Study of Plasma Electrolytic Oxidation Treated Zr3Al Based Alloy in 300°C/14 MPa Lithium Borate Buffer Solution

Discharge behaviors during plasma electrolytic oxidation on aluminum alloy

Microstructures and Abrasive Properties of the Oxide Coatings on Al6061 Alloys Prepared by Plasma Electrolytic Oxidation in Different Electrolytes

Surface Charge and Corrosion Behavior of Plasma Electrolytic Oxidation Film on Zr3Al Based Alloy

Application of Plasma Electrolytic Oxidation to the Novel Aircraft Aluminum Alloy for Enhancing Corrosion Resistance

Comparison of Plasma Electrolytic Oxidation of Zirconium Alloy in Silicate- and Aluminate-Based Electrolytes and Wear Properties of the Resulting Coatings