Abstract:Fault Tolerant Control Systems (FTCS) have emerged as a critical area of study for enhancing the safety, reliability, and efficiency of modern control systems. The FTCS technique might be active or passive control in general. In this paper, the active control branch's Fault Detection and Diagnosis (FDD) is used to detect faults in DC motor speed sensors. FDD methodologies can be divided into two types based on the process and the type of data available: model-based methods and data-based methods. The proposed method here investigates the use of the Luenberger observer technique, which is part of the model-based approach. The selected method was implemented and experimentally evaluated. This observer is dependent on the residual signal, which serves as a fault indicator in the overall system and represents the difference between the measured and estimated speed signals from the plant. Due to the increasing demand for these motors, particularly in electro-mechanical applications such as robotics, elevators, and electric-driven railways, a DC motor was chosen as a benchmark to test the proposed method. The output speed of the motor was subjected to four sensor faults: sensor fault, abrupt fault, intermittent fault, and incipient fault. The effectiveness of the suggested approach is demonstrated using MATLAB simulations, and the results show that faults are detected as anticipated with a high-performing response. Therefore, the proposed method was also implemented experimentally in real time and the obtained results showed a close match with those from simulation, thus proving the accuracy and reliability of the proposed methodology for fault detection in the DC motor speed sensor.

Speed and Current Sensor Fault Detection and Isolation Based on Adaptive Observers for IM Drives

Speed-Sensorless Control of Induction Motor Drives with A Delay-Based Frequency Estimation Method

Current Sensor Fault-Tolerant Control Strategy for Speed-Sensorless Control of Induction Motors Based on Sequential Probability Ratio Test

A Delay-Based Frequency Estimation Scheme for Speed-Sensorless Control of Induction Motors

Speed sensorless fault-tolerant control of induction motor drives against current sensor fault

A SENSOR FAULT-TOLERANT CONTROL SOLUTION BASED ON CURRENT OBSERVERS APPLIED TO THREE PHASE INDUCTION MOTOR DRIVE

Speed-Sensorless Control of Induction Motor Drives with a STA-FLL Speed Estimation Scheme

Online Decoupled Stator and Rotor Resistances Adaptation for Speed Sensorless Induction Motor Drives by a Time-Division Approach

Adaptive Sensorless Control of High Speed Surface-Mounted PMSM Drives with Inductance Estimator Based on Current Error

Fault-Tolerant Technique against Current Sensors for Model Predictive Control of Induction Motor Drives

Sensor Fault Diagnosis Method Based on Rotor Slip Applied to Induction Motor Drive

Stable Simultaneous Stator and Rotor Resistances Identification for Speed Sensorless IM Drives: Review and New Results

A Speed Estimation Scheme Based on an Improved SOGI-FLL for Speed-Sensorless Control of Induction Motor Drives.

Alternative Solution Regarding Problems of Adaptive Observer Compensating Parameters Uncertainties for Sensorless Induction Motor Drives

Current sensor unanticipated fault detection and compensation of 14.5-meter optical/infrared telescope drive system based on algebraic transformations

Speed and current sensor fault-tolerant induction motor drive for electric vehicles based on virtual sensors

Resistances and Speed Estimation in Sensorless Induction Motor Drives Using a Model With Known Regressors.

High Dynamic Sensorless Control for PMSMs Based on Decoupling Adaptive Observer

Fault-Tolerant Control Based on Current Space Vectors against Total Sensor Failures

Luenberger Observer-Based Speed Sensor Fault Detection: real time implementation to DC Motors

Current sensor fault‐tolerant control strategy for surface‐permanent‐magnet‐synchronous motor drives based on improved full‐order sliding‐mode observer