Abstract:Bimetallic catalysts are of great interest because they often display properties that differ from either of their parent metals. Previous studies on the Ni/Pt(111) bimetallic system have shown that the location of Ni atoms in the Pt(111) surface has a strong influence on the electronic and chemical properites of the surface [1]. The bimetallic surface consisting of a monolayer of Ni on top of bulk Pt(111), designated Ni-Pt-Pt(111), binds hydrogen and alkenes much more strongly than either parent metal, resulting in decreased hydrogenation activity. In contrast the surface consisting of a monolayer of Ni atoms in the subsurface region designated as Pt-Ni-Pt(111), has been shown to weaken metal-hydrogen bonds in comparison to Ni-Pt-Pt(111) or either parent metal surface. The resulting abundance of weakly bound hydrogen and alkenes on the Pt-Ni-Pt(111) surface increases its activity for novel low temperature hydrogenation pathways [2, 3]. In a previous attempt to extend these single crystal surface science studies to supported catalysts, PtCo bimetallic catalysts were found to be more active to hydrogenation reactions than PtNi bimetallic catalysts [4]. Therefore this study will focus on PtCo catalysts and the effect of different support materials on catalyst structure and activity. Co and Pt monometallic and PtCo bimetallic catalysts were synthesized and supported on γ-Al 2O 3, SiO 2, TiO 2, and activated carbon (AC). Temperature programmed reduction (TPR) studies were performed to characterize the reduction behavior of the catalysts and to identify suitable reduction conditions. CO chemisorption was used to determine the number of active sites on each catalyst. Flow reactor studies of benzene hydrogenation the series of catalysts were used to compare the activity of PtCo on the different supports. Normalizing the hydrogenation activity with the number of active sites yielded the following trend in activity: SiO 2 → Al 2O 3 → TiO 2 ∼ AC. Activation barriers were also calculated and followed a trend consistent with the normalized activity trend, that is: SiO 2 < Al 2O 3 < TiO 2 ∼ AC. Extended X-ray absorption fine structure (EXAFS) spectroscopy was used to characterize the extent of bimetallic formation. EXAFS analysis found that the SiO 2 and Al 2O 3 supported catalysts showed a greater extent of bimetallic formation (larger Pt-Co coordination number) than either the TiO 2 or AC supported catalysts. Both the TiO 2 and AC supported catalysts possessed large Pt-Pt coordination numbers, suggesting the presence of larger particles. Transmission electron microscopy (TEM) was utilized to characterize the particle sizes. Particles on the SiO 2 supported catalyst appeared to be the smallest and most dispersed, while larger particles were observed in both the TiO 2 and AC supported catalysts.

Controlling Hydrogenation of CO and CC Bonds in Cinnamaldehyde Using Silica Supported Co-Pt and Cu-Pt Bimetallic Catalysts

Selectivity of Gold Catalysts for Selective Hydrogenation of Cinnamaldehyde

Pt-Re/rGO Bimetallic Catalyst for Highly Selective Hydrogenation of Cinnamaldehyde to Cinnamylalcohol

Highly Efficient Selective Hydrogenation of Cinnamaldehyde to Cinnamyl Alcohol over CoRe/TiO2 Catalyst.

Highly stable Pt-Co bimetallic catalysts prepared by atomic layer deposition for selective hydrogenation of cinnamaldehyde

Aqueous phase selective C O hydrogenation of cinnamaldehyde over bimetallic RuCo catalysts with electronic and geometric modification

Selective hydrogenation of cinnamaldehyde to cinnamyl alcohol with carbon nanotubes supported Pt-Co catalysts

Bimetallic Pt-Co catalysis on carbon nanotubes for the selective hydrogenation of cinnamaldehyde to cinnamyl alcohol: Preparation and characterization

Preparation and Characterization of Polymer-Protected PtCo Bimetallic Colloids and Their Catalytic Properties in the Selective Hydrogenation of Cinnamaldehyde

Enhanced Activity of Alkali-Treated ZSM-5 Zeolite-Supported Pt-Co Catalyst for Selective Hydrogenation of Cinnamaldehyde

Electronic Metal−Support Interaction Strengthened Pt/CoAl‐LDHs Catalyst for Selective Cinnamaldehyde Hydrogenation

Support effect on the low-temperature hydrogenation of benzene over PtCo bimetallic catalysts

Electron synergy effect in the PtCo/CNTs bimetallic catalysts for promoting highly selective and stable hydrogenation of crotonaldehyde

Selective hydrogenation of cinnamaldehyde with Ni Fe1-Al2O4+ composite oxides supported Pt catalysts: C O versus C C selectivity switch by varying the Ni/Fe molar ratios

Support Effect on the Low-Temperature Hydrogenation of Benzene over PtCo Bimetallic and the Corresponding Monometallic Catalysts

Effect of Transition Metals (cr, Mn, Fe, Co, Ni and Cu) on Selective Hydrogenation of Cinnamaldehyde over Pt/Cnts Catalyst

Regulating Hydrogenation Chemoselectivity of α,β-Unsaturated Aldehydes by Combination of Transfer and Catalytic Hydrogenation with Ammonia Borane and Pt/MOL.

Enhanced Selective Hydrogenation of Cinnamaldehyde to Cinnamyl Alcohol over Silica-Coated Pt-Co x O y Hybrid Nanoparticles

Semi-hydrogenation of α,β-unsaturated aldehydes over sandwich-structured nanocatalysts prepared by phase transformation of thin-film Al2O3 to Al-TCPP

Precise regulation of Mo 2 N–TiO 2 deposited Pt nanoparticles induced synergistic effect for the hydrogenation of cinnamaldehyde

Screening Support Effect of Pt/Mox for Selective Hydrogenation of Cinnamaldehyde