Abstract:Electrical capacitance tomography (ECT) has been widely applied in gas-fluidized bed measurements, which however is constrained by the sensor designs, image reconstruction algorithms and concentration models owing to the "soft-field " nature. Among the three factors, the concentration models that map the permittivity to solid concentration distribution are less understood. In this paper we present an experimental investigation on the effects of concentration models for the ECT measurements of gas-fluidized beds containing Geldart's group A particles. The results show that the bubble velocity, bubbling frequency and fluidization regime transition velocity are intrinsic whatever the concentration model employed. However, the time-averaged solid concentrations measured by ECT with the conventional concentration models are usually higher than the corresponding results obtained by the bed expansion experiments in homogeneous fluidization. It has been further found that the concentration models can significantly influence the threshold selection in identifying the bubbles and surrounding emulsion phase in gas-fluidized beds. Thus, a new concentration model given in the formula of a power function (phi = G(alpha)) has been proposed, with the optimal exponent alpha obtained via the least-square fitting of solid concentration in bed expansion during homogeneous fluidization. The model is robust and the sensitivity analysis shows that the variation of time-averaged solid concentration is negligible (& LE; 3%) suppose that alpha changes by & PLUSMN; 20%.

Concentration Measurement of Dilute Pulverized Fuel Flow by Electrical Capacitance Tomography

Pulverized-Coal Concentration Measurement Based on Electrical Capacitance Tomography

An Online Flow Pattern Identification System for Gas-Oil Two-Phase Flow Using Electrical Capacitance Tomography

Application of Electrical Capacitance Tomography in Dense-Phase Pneumatic Conveying of Pulverized Coal under High Pressure

Electrical Capacitance Tomography In Dense-Phase Pneumatic Conveying Of Pulverized Coal Under High Pressure

An ECT Flow Regime Identification Technology for Gas/solid Two-phase Flow Phase Concentration Measurement

Application of a Digital ECT System for Measurements of Dense-Phase Gas-Solid Flows

A Dual Modality Tomography System for Particle Concentration and Charge Distribution Measurement in Dense-Phase Pneumatic Conveyor of Pulverized Coal

Ect Technique and Its Application to Gas/Solid Flows Concentration Measurement

Gas–oil two-phase flow measurement using an electrical capacitance tomography system and a Venturi meter

Electrical Capacitance Tomography for Gas–solids Flow Measurement for Circulating Fluidized Beds

Thick-wall electrical capacitance tomography and its application in dense-phase pneumatic conveying under high pressure

Experimental study on gas–solids flows in a circulating fluidised bed using electrical capacitance tomography

Application Of Electrical Capacitance Tompgraphy To Gas-Solid Fluidized Beds: Dynamic Behavior Monitoring

Dynamical Lag Correlation Exponent Based Method for Gas–solid Flow Velocity Measurement Using Twin-Plane Electrical Capacitance Tomography

Online Monitoring of Gas-Solid Two-Phase Flow Using Projected Cg Method in Ect Image Reconstruction

Flow Velocity Measurement Using Twin-plane Electrical Capacitance Tomography Technique

Flow Pattern Characteristics in Vertical Dense-Phase Pneumatic Conveying of Pulverized Coal Using Electrical Capacitance Tomography

Dense-phase Pneumatic Conveying under Pressure in Horizontal Pipeline

Sensor Monitoring and Online Measurement Correction in Electric Capacitance Tomography System

On the Concentration Models in Electrical Capacitance Tomography for Gas-Fluidized Bed Measurements