Abstract:The discrete cohesive zone model (DCZM) is implemented using the finite element (FE) method to simulate fracture initiation and subsequent growth when material non-linear effects are significant. Different from the widely used continuum cohesive zone model (CCZM) where the cohesive zone model is implemented within continuum type elements and the cohesive law is applied at each integral point, DCZM uses rod type elements and applies the cohesive law as the rod internal force vs. nodal separation (or rod elongation). These rod elements have the provision of being represented as spring type elements and this is what is considered in the present paper. A series of 1D interface elements was placed between node pairs along the intended fracture path to simulate fracture initiation and growth. Dummy nodes were introduced within the interface element to extract information regarding the mesh size and the crack path orientation. To illustrate the DCZM, three popular fracture test configurations were examined. For pure mode I, the double cantilever beam configuration, using both uniform and biased meshes were analyzed and the results show that the DCZM is not sensitive to the mesh size. Results also show that DCZM is not sensitive to the loading increment, either. Next, the end notched flexure for pure mode II and, the mixed-mode bending were studied to further investigate the approach. No convergence difficulty was encountered during the crack growth analyses. Therefore, the proposed DCZM approach is a simple but promising tool in analyzing very general two-dimensional crack growth problems. This approach has been implemented in the commercial FEA software ABAQUS® using a user defined subroutine and should be very useful in performing structural integrity analysis of cracked structures by engineers using ABAQUS®.

Modeling Mixed Mode Fracture Of Concrete By Using The Combined Discrete And Finite Elements Method

MESOSCALE FRACTURE MODELING OF FOUR-PHASE CONCRETE USING A DEM-ENHANCED STRUCTURE GENERATION METHOD

A Mesoscale Modelling Approach Coupling SBFEM, Continuous Damage Phase-Field Model and Discrete Cohesive Crack Model for Concrete Fracture

Hybrid Phase-Field Modeling of Mesoscopic Failure in Concrete Combined with Fourier-Voronoi Stochastic Aggregate Distribution Modelling Approach

SIMULATION OF MIXED-MODE FRACTURE OF CONCRETE USING EXTENDED FINITE ELEMENT METHOD

Finite Element Simulation of Mixed-Mode I-II Dynamic Fracture of Concrete Based on an Initial Fracture Toughness-Based Criterion

Ⅰ/Ⅱ TENSILE-SHEAR MIXED MODE FRACTURE SIMULATION BY 3D DISCRETE ELEMENT METHOD

Two-Dimensional Meso-Scale Simulation of Hydraulic Fracture in Concrete

An embedded cohesive crack model for finite element analysis of mixed mode fracture of concrete

A Multiphase Mesostructure Mechanics Approach to the Study of the Fracture-Damage Behavior of Concrete

Discrete Cohesive Zone Model for Mixed-Mode Fracture Using Finite Element Analysis

A Numerical Analysis with Scaled Boundary Finite Element Method to Simulate Mixed-mode Crack Propagation for Concrete Beams

3D Finite Element Simulation of Complex Static and Dynamic Fracture in Quasi-Brittle Materials

Simulation of Meso-Fracture the Extended Finite Process of Concrete Using Element Method

Modeling of the Fracture Behaviors of Concrete Using 3D Discrete Element Method with Softening Effect

A sophisticated simulation for the fracture behavior of concrete material using XFEM

An Efficient FE–SBFE Coupled Method for Mesoscale Cohesive Fracture Modelling of Concrete

Mesoscopic Numerical Simulation of Fracture Process and Failure Mechanism of Concrete Based on Convex Aggregate Model

Phase Field Model for Mixed Mode Fracture in Concrete

Composite Interface Damage Model in Concrete Fracture Process and Associated Numerical Simulation

Continuum–Discontinuum Bonded-Block Model for Simulating Mixed-Mode Fractures