Abstract:To clarify the CO-tolerant mechanism at Pt-based alloy anode catalysts, surface-enhanced infrared reflection-absorption spectroscopy with the attenuated total reflection technique(ATR-SEIRAS), coupled with CV measurement, was used to observe the oxidation process of adsorbed CO on a typical Pt-Fe (Pt-Fe = 0.27/0.73) alloy. The alloy electrode exhibits a lower saturated coverage of CO.(theta(CO) = 0.55) than that of pure Pt (theta(CO) = 1.0). The dominating linear CO is observed around 2000 cm(-1) when the equilibrium adlayer of CO covers the alloy electrode; however, linear and bridged CO and also GOON were found at the pure Pt electrode at the same CO coverage in the non-steady-state, On the basis of our previous results that a Pt skin is formed during the repetitive potential cycling due to the dissolution of Fe on the alloy surface and the skin exhibits less electronic density in the d band, it can be explained that the lowered linear CO coverage and almost no bridged CO are obtained as the result of the lowered back-donation of d electrons from the Pt skin to adsorbates on the alloy surface. The wavenumber shift of the linear CO stretching to a lower value at the alloy, which is not simply predicted by the lowering of the back-donation of the d electron, is ascribed to the weakening of the C-Pt bond. As a presumable effect of the electronic structure change at the Pt skin, the dissociation-oxidation of adsorbed water as well as a formation of adsorbed HOOH species are clearly observed beyond 0.6 V in the electrolyte solution without CO, which is different from that at the pure Pt electrode. Carbonate species can also be detected around 1300-1450cm(-1), which are possibly produced by the surface-reaction of CO2 with water.

CO Oxidation on Pt ‐ Ru / WO 3 Electrodes

CO Oxidation on Pt-Ru/WO[sub 3] Electrodes

Electrocatalysis of Oxygen Reduction on Carbon-Supported PtCo Catalysts Prepared by Water-in-oil Micro-Emulsion

Anodic-Oxidation of Methanol on Pt/Wo3 in Acidic Media

Co-deposited Pt–WO3electrodes. Part 1.—methanol Oxidation and in Situ FTIR Studies

CO Oxidation on Ru-Pt Bimetallic Nanoclusters Supported on TiO2(101): the Effect of Charge Polarization

Oxidation of CO on a Pt−Fe Alloy Electrode Studied by Surface Enhanced Infrared Reflection−Absorption Spectroscopy

Anodic Oxidation of Impure H 2 on Teflon‐Bonded Pt ‐ Ru / WO 3 / C Electrodes

Catalytic oxidation of CO over Pt/Fe3O4 catalysts: Tuning O2 activation and CO adsorption

In-situ SERS Study of the Electrooxidation of Formic Acid on Pt-Ru Electrode

Effect of Rare Earth Eu~(3+) Modified Electrode Pt-TiO_2/Eu~(3+)/C on CO Oxidation

A facile method to synthesize well-dispersed PtRuMoOx and PtRuWOx nanoparticles and their electrocatalytic activities for methanol oxidation

In Situ Electrochemical FTIR Spectroscopy of Adsorption and Oxidation Process of Methanol on PtRu/C Electrocatalyst

Effect of Eu3+ Adsorbed on Pt/C Electrode for the Oxidation of CO in Sulfuric Acid

Early Stages During the Oxidation of HCOOH on Single-Crystal Pt Electrodes As Characterized by Infrared Spectroscopy

Anodic Oxidation of Formic Acid on Electrodeposited Pt / WO 3 Electrode at Room Temperature

Electro-Oxidation of Ethanol on Pt-WO[sub 3]∕C Electrocatalyst

Investigation of Ethanol Electro-Oxidation on Pt-Ru-W/C Catalyst

CoPt Nanoparticles and Their Catalytic Properties in Electrooxidation of CO and CH(3)OH Studied by in Situ FTIRS.

In Situ Raman Study of CO Electrooxidation on Pt(hkl) Single‐Crystal Surfaces in Acidic Solution

High Regularity Porous Oxophilic Metal Films on Pt As Model Bifunctional Catalysts for Methanol Oxidation