Abstract:As the third generation solar cell,dye-sensitized solar cells (DSSCs) have attracted tremendous amount of interest in scientific research and industrial applications during the past 25 years because of their simple production procedures,low-cost,environmental friendliness of raw materials,and relatively high power conversion efficiency (PCE).As an important component,counter electrode (CE) not only transfers electrons flowing from the external circuit to the electrolyte,but also catalyzes the reduction of oxidized electrolyte at the CE/electrolyte interface.So far,Pt as a noble metal has been the most commonly used CE for laboratory research due to its excellent electrocatalytic activity,high conductivity and good chemical stability.Unfortunately,the high cost and low abundance ratio of Pt create a big obstacle for large-scale applications of DSSCs.Therefore,exploiting Pt-free CE materials with high electrocatalytic activity and low cost is vital for the practical applications.Recently,a lot of Pt-free materials,such as graphene,carbon,conductive polymers and metal compounds (including carbide,oxide,sulfide,nitride and selenide),have been proposed for use as the CE of DSSCs.Among those materials,metal selenides have drawn great interest due to their distinctive electronic structures,interesting chemical behaviors and distinctive physical properties.The electrocatalytic activity of a substance not only depends on the chemical composition but also relies on the morphology of materials.While the investigation on developing new electrocatalysts has been extensively conducted,the morphology effect on the electrocatalytic activity has rarely been studied.In this paper,a simple low temperature hydrothermal method was used to synthesize NiSe2 with nanorod (r-NiSe2) and nanoparticle (p-NiSe2) morphologies.A drop-cast method was used to fabricate CE films without any post-treatment.Since the only difference for those two CEs used in DSSC is their morphology,it allows us to study the morphology effect on the electrocatalytic activity and solar cell performances.By changing the drop-cast times,the loading amount from 5.0 to 80.0 μg/cm2 could be controlled.The PCE of DSSCs increases with increasing the loading amount up to 10 μg/cm2 and then decreases with further increasing the loading amount of NiSe2.Thus,the best loading amount has been determined to be 10 μg/cm2.All the measurements in this paper are based on the best loading amount.The DSSC with r-NiSe2 CE achieves PCE of 8.52％,which is higher than that for the p-NiSe2 based DSSC (8.13％) and even better than the Pt based DSSC (8.20％) at comparable conditions.This indicates that NiSe2 nanorod is better than NiSe2 nanoparticle as the CE of DSSCs towards higher photovoltaic performance.To elucidate the catalytic activity of r-NiSe2 and p-NiSe2,electrochemical impedance spectroscopy,Tafel polarization curve and cyclic voltammetry were conducted.The experimental results indicate that the r-NiSe2 CE exhibits higher electrocatalytic activity than p-NiSe2 CE,which explains the reason that the DSSC based on r-NiSe2 CE has the higher PCE than the p-NiSe2 CE.The result implies that by varying the morphologies of CE materials could also fulfill the improvement of solar cell's performance.

Morphology–Property Effect in Electrocatalysis Based on Ni1-χSe@Graphene Series with Specific Stoichiometric Ratio

Synthesis of NiSe<sub>2</sub>/Fe<sub>3</sub>O<sub>4</sub> Nanotubes with Heteroepitaxy Configuration as a High‐Efficient Oxygen Evolution Electrocatalyst

Synthesis of NiSe2/Fe3O4 Nanotubes with Heteroepitaxy Configuration as a High-Efficient Oxygen Evolution Electrocatalyst

Morphology Effect of NiSe Hierarchical Microspheres on the Performance of Dye-Sensitized Solar Cells

Highly Efficient Dye-Sensitized Solar Cells with NiSe2 Counter Electrodes: Effect of Morphology on the Electrocatalytic Activity and the Photovoltaic Performance

Exploring the electrochemical properties of CuSe-decorated NiSe2 nanocubes for battery-supercapacitor hybrid devices

General Synthesis of Hierarchically Macro/Mesoporous Fe,Ni-Doped CoSe/N-Doped Carbon Nanoshells for Enhanced Electrocatalytic Oxygen Evolution

Optimizing the electronic structure of NiSe2/CoSe2 nanosheet arrays by phosphorus doping for high-efficiency oxygen evolution electrocatalysts

Morphology Reconstruction and Electronic Optimization: Nickel-Iron Selenide Nanospheres with Mo-Doping as an Efficient Bifunctional Electrocatalyst for Overall Water Splitting

Spectroscopically unraveling high-valence Ni-Fe catalytic synergism in NiSe2/FeSe2 heterostructure

Morphology modulation of NiCo2S4 arrays in-situ growth on carbon cloth for high performance flexible supercapacitor electrode

Synthesis of Nise2/Reduced Graphene Oxide Crystalline Materials and Their Efficient Electrocatalytic Activity in Dye-Sensitized Solar Cells

NiSe2/Ni5P4 nanosheets on nitrogen-doped carbon nano-fibred skeleton for efficient overall water splitting

Hierarchical NiCo2Se4 Arrays Composed of Atomically Thin Nanosheets: Simultaneous Improvements in Thermodynamics and Kinetics for Electrocatalytic Water Splitting in Neutral Media

In-situ growth of CNTs encapsulating P-doped NiSe2 nanoparticles on carbon framework as efficient bifunctional electrocatalyst for overall water splitting

Morphology-optimized interconnected Ni3S2 nanosheets coupled with Ni(OH)2 nanoparticles for enhanced hydrogen evolution reaction

Morphology and Properties of NiO Electrodes for P-Dsscs Based on Hydrothermal Method

Regulating the electronic structure of ultrathin Ni-based chalcogenide nanosheets through iron modification towards high electrocatalytic activities

Surface reconstruction of Se-doped NiS 2 enables high-efficiency oxygen evolution reaction

Tailoring Mo-Doped NiCoP Grown on (Ni,Co)Se 2 Nanoarrays for Asymmetric Supercapacitor with Enhanced Electrochemical Performance

Growth of NiS/graphene Nanocomposites for Enhanced Performance of Dye Sensitized Solar Cells