Abstract:Broadband electromagnetic vibration energy harvesters (EMVEHs) can effectively convert mechanical energy into electricity from human motions with low and random frequencies. However, such applications require a small device footprint which limits the power density of the energy harvester, making it hard to generate sufficient energy for wearable electronics. Here, we present a design of a nonresonant broadband EMVEH based on a magnet array with alternating magnetic polarities and microfabricated planar coils. To enhance the power output and power density of the EMVEH, we propose a geometric optimization method for determining the coil geometry. First, the magnetic flux density (MFD) distribution and the power output under different types of excitation motions are studied by finite element analysis and numerical simulation, respectively. Based on these results, a design of a stackable microfabricated double-sided planar coil sheet consisting of 10 coil groups is chosen. Through the optimization based on the trade-off between induced voltage and coil resistance, four coil turns in each coil group is determined as the optimal design for maximizing the output power, which proved independent of the excitation conditions. Based on the optimized design, a prototype consisting of 20 layers of coil sheets connected in series on each side is fabricated, occupying only 1.73 cm3. The device is tested to have a wide half-power bandwidth of 8 Hz, a maximum output power of 346.7 mu W, and a maximum power density of 200.4 mu W/cm3 , when connected to a matched load of 69.46 omega under sinusoidal excitations of 2.0 g acceleration. Furthermore, we propose a preliminary optimization methodology to determine the optimal number of stacked coil layers.

Design and Analysis of A Plane Vibration-Based Electromagnetic Generator Using A Magnetic Spring and Ferrofluid

An Electromagnetic Energy Harvester Using Ferrofluid As a Lubricant

Electromagnetic Human Motion Generator with Magnetic Spring and Ferrofluid

Design Optimization of Microfabricated Coils for Volume-Limited Miniaturized Broadband Electromagnetic Vibration Energy Harvester

Development of a Dual-Dof Vibration Energy Harvester Using a Foldable Spring Pendulum Mechanism

A multi-frequency electromagnetic vibration energy harvester based on ferrofluid

Electromagnetic vibration energy harvester using magnetic fluid as lubricant and liquid spring

Analysis and Experiments of a Pendulum Vibration Energy Harvester with a Magnetic Multi-Stable Mechanism

Comparison of Vibration Energy Harvesters with Fixed and Unfixed Magnetic Springs

Design and Fabrication of A Micro Electromagnetic Vibration Energy Harvester

Resonant Frequency Reduction of Vertical Vibration Energy Harvester by Using Negative-Stiffness Magnetic Spring

Energy Scavenging From Low Frequency Vibrations Through a Multi-Pole Thin Magnet and a High-Aspect-Ratio Array Coil

Model and Experimental Study of Permanent Magnet Vibration-to-Electrical Power Generator

Copper foil-type vibration-based electromagnetic energy harvester

A nonlinear electromagnetic vibration energy harvester lubricated by magnetic fluid for low-frequency vibration

An electromagnetic vibration energy harvester with compact flexure guide for low frequency applications

Bi-stable electromagnetic generator with asymmetrical potential wells for low frequency vibration energy harvesting

A low-frequency vibration energy harvester employing self-biased magnetoelectric composite

A Ferrofluid-Based Tuned Mass Damper with Magnetic Spring

Design and Experimental Characterization of a Vibration Energy Harvesting Device for Rotational Systems

Ultra-Low Frequency Eccentric Pendulum-Based Electromagnetic Vibrational Energy Harvester