Pulsed Laser‐triggered Piezoelectric Photocatalytic CO2 Reduction Over Tetragonal BaTiO3 Nanocubes
Yijie Wang,Xiao Li,Yuke Chen,Yue Li,Zhen Liu,Chaoqiong Fang,Tong Wu,Hongsen Niu,Yang Li,Wanggen Sun,Wenjing Tang,Wei Xia,Kepeng Song,Hong Liu,Weijia Zhou
DOI: https://doi.org/10.1002/adma.202305257
IF: 29.4
2023-08-04
Advanced Materials
Abstract:The recombination of photo‐induced carriers in photocatalysts has been considered as one of the most barriers for the increase of photocatalysis efficiency. Piezoelectric photocatalyst opens a new route to realize rapid carrier separation by mechanically distorting lattice of piezoelectric nanocrystals to form a piezoelectric potential within the nanocrystals, generally requaring external force (e.g., the ultrasonic radiation, mechanical stirring and ball milling). In this study, the low power ultraviolet (UV) pulsed laser (PL, 3 W, 355 nm) as UV light source can trigger piezoelectric photocatalytic CO2 reduction of tetragonal BaTiO3 (BTO‐T) in the absence of applied force. The transient tremendous light pressure (5.7×107 Pa, 2.7 W) of 355 nm PL not only bends the energy band of BTO‐T, thus allowing reactions that cannot theoretically occur to take place, but also induce a pulsed build‐in electric field to determine an efficient photoinduced carrier separation. On that basis, the PL triggered piezoelectric photocatalytic CO2 reduction realizes the reported highest performance, reaching the millimole level CO yield of 52.9 mmol g−1 h−1, and achieving efficient photocatalytic CO2 reduction in the continuous catalytic system. The method in this study is promising to contribute to the design of efficient piezoelectric photocatalytic reactions. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology