Abstract:In this paper, the wavelength modulation spectroscopy (WMS) technique is modified and used for measuring methane with large absorbance. The WMS has been frequently used for gas measurement and relies on the linear relationship between the second harmonic amplitude and the gas volume concentration. However, the conventional WMS technique is only applicable for the gas whose absorbance is much smaller than 1, which is because the first-order approximation of Lambert-Beer's law is required in the derivation of the traditional WMS theory, and the first-order approximation holds only at low absorbance, hence the linear relationship between the second harmonic and the gas concentration does not hold at large absorbance. In the modified WMS in this work, it is not necessary to make any approximation to Lambert-Beer's law. The measured light is absorbed by the gas to be measured and then collected by the photodetector. The reference light is directly detected by another photodetector without being absorbed. The output signals of the two photodetectors are transmitted to the computer after implementing analog-to-digital conversion. In this way, the demodulated second harmonic signal remains linear with the gas concentration even at large absorbance. In this work, the traditional WMS theory and the modified WMS theory are both introduced, and a series of methane gas with concentration gradients are measured separately. The experimental results of the traditional WMS and the modified WMS are compared with each other. It is confirmed that the linearity in the traditional WMS theory no longer holds under large absorbance, but the improved WMS can still guarantee the linear relationship between the second harmonic and the methane concentration, which verifies the advantages of the modified scheme. Finally, through Allan's standard deviation analysis, the stability of this methane measurement system reaches the optimal value at the average time of 103.6 s, and the corresponding Allan's standard deviation is 1/26.62×10–9 volume.

A Method for the Measurement of Methane Gas Based on Multi-beam Interferometry

Fiber Methane Gas Detection Technology Research Based on LabVIEW

Absorption Measurement of Methane Gas with Broadband Light Source Using Fiber-Optic Sensor System

Integrated optical-fiber sensing system based on infrared absorption for measuring concentration of methane

Measurement of Methane Gas with High Absorbance Based on Modified Wavelength Modulation Spectroscopy

Methane Sensing via Unbalanced Nonlinear Interferometry using a CMOS Camera

Methane Sensing System Based on Infrared Absorption

Comb Filter-Based Fiber-Optic Methane Sensor System with Mitigation of Cross Gas Sensitivity

Methane sensing in the mid-IR using short wave IR photon counting detectors via non-linear interferometry

Multiplexed Fiber-optic Methane Sensors Based on Optical Coherence Domain Reflectometry

A Fiber-optic Gas Sensor for Methane

Development of a Methane-Detection System Using a Distributed Feedback Laser Diode and Hollow-Core Photonic Crystal Fiber

Methane Gas Detection Based on Anti- Resonant Hollow-Core Fiber

Research on High Performance Methane Gas Concentration Sensor Based on Pyramid Beam Splitter Matrix

Multiline absorption spectroscopy for methane gas detection.

Enhanced Photoacoustic Spectroscopy Integrated with a Multi-Pass Cell for Ppb Level Measurement of Methane

Trace Gas Measurement Method Based on Dual Wavelength Modulation of Distributed Feedback Laser

A high-sensitive methane measuring telemetry system based on a direct optical absorption technique

Multipoint Remote Methane Measurement System Based on Spectrum Absorption and Reflective TDM

A Fiber-Optic Methane Gas Sensor System with Improved Accuracy Using Absorption-Spectrum Matched Comb Filter

Methane measurement method based on F-P angle-dependent correlation spectroscopy