Abstract:For the battery- or USB-powered portable smart devices, which supply their computing cores with a wide-range sub-volt rail, the energy-efficient high and wide voltage-conversion-ratio (VCR) converters are crucially important. In addition, low form factor and decent transient responses are also favorable for such applications. Prior state-of-the-art designs either use single-stage hybrid designs using multi-level or Dickson converters [1 – 3], or adopt two-stage cascaded architectures with a highly efficient unregulated front (or rear) stage [4], as shown in Fig. 18.6.1 (left). The multi-level designs, which conduct the full inductor current through all the on-state switches, are suited to low-to-medium power levels with limited current density. The Dickson converters take advantage of a high conversion ratio, however, at the cost of reduced output voltage range. The two-stage designs which show decent output range and efficiency, however, can suffer from heavy load efficiency degradation considering that the efficiency of both stages degrade with increasing load and the overall efficiency which is the product of the efficiencies of the two stages is severely degraded. Inspired by the inductive-sigma converter [5] which shunts a highly efficient unregulated LLC with a regulated Buck, this work proposes a reconfigurable capacitive-sigma converter. By input-series and output-shunting a highly efficient unregulated switched-capacitor (SC) converter with a reconfigurable Dickson hybrid Buck stage, the power stage input current is reused and output currents are combined. Therefore, the overall efficiency is greatly improved in a wide continuous VCR range and with an enhanced loading capacity. Besides, as will be demonstrated, the proposed design shows inherently decent load transient and regulation performances.

Reconfigurable self-timed regenerators for wide-range voltage scaled interconnect

A 2-Gb/s/pin Source Synchronous CDMA Bus Interface with Simultaneous Multi-Chip Access and Reconfigurable I/O Capability

A 5V Input 98.4% Peak Efficiency Reconfigurable Capacitive-Sigma Converter with Greater Than 90% Peak Efficiency for the Entire 0.4~1.2V Output Range.

Design of a Reconfigurable Multifunctional Standard Cell for Engineering Change Order

Minimal-Power, Delay-Balanced Smart Repeaters for Global Interconnects in the Nanometer Regime

Reconfigurable Designs for Networking Silicon.

A Low-Cost High-Performance Voltage Sensing Circuit with Proactive Parameter Design Compensation Network for SiC MOSFETs.

ReVIVaL: A Variation-Tolerant Architecture Using Voltage Interpolation and Variable Latency

A reconfigurable ΣΔ modulator for multi-standard wireless application

A high-reliability SEPIC converter with reconfigurable voltage conversion gain

A 0.1pj/b 5-to-10gb/s Charge-Recycling Stacked Low-Power I/O for On-Chip Signaling in 45nm CMOS SOI

A 130-Nm Ferroelectric Nonvolatile System-on-Chip with Direct Peripheral Restore Architecture for Transient Computing System

AgileRegulator: A hybrid voltage regulator scheme redeeming dark silicon for power efficiency in a multicore architecture

A 1.8 Pj/Bit 16 X 16 Gb/S Source-Synchronous Parallel Interface in 32 Nm Soi Cmos with Receiver Redundancy for Link Recalibration

A Reconfigurable Seamless-Transition Dc-Dc Converter with Lossless Current-Sensing Technique

A Dual-rail Based Dynamic Voltage and Frequency Scaling for Wide-Voltage-Range Processor

Areconfigurable Sigma Delta Modulator For Multi-Standard Wireless Application

Connect on the Fly: Enhancing and Prototyping of Cycle-Reconfigurable Modules

Dynamic Voltage and Frequency Scaling for Intermittent Computing

Power Optimization with Interconnect Repeater Heat Transferance Effect

A 0.79 pJ/K-Gate, 83% Efficient Unified Core and Voltage Regulator Architecture for Sub/Near-Threshold Operation in 130 nm CMOS