Abstract:By choosing more orthogonality between pre-selection and post-selection states, one can significantly improve the sensitivity in the general optical quantum metrology based on the weak-value amplification (WVA) approach. However, increasing the orthogonality decreases the probability of detecting photons and makes the weak measurement difficult, especially when the weak measurement is disturbed by strong noise and the pointer is drowned in noise with a negative-dB signal-to-noise ratio (SNR). In this article, we investigate a modified weak measurement protocol with a temporal pointer, namely, the auto-correlative weak-value amplification (AWVA) approach. Specifically, a small longitudinal time delay (tiny phase shift) $\tau$ of a Gaussian pulse is measured by implementing two simultaneous auto-correlative weak measurements under Gaussian white noise with different SNR. The small quantities $\tau$ are obtained by measuring the auto-correlation coefficient of the pulses instead of fitting the shift of the mean value of the probe in the standard WVA technique. Simulation results show that the AWVA approach outperforms the standard WVA technique in the time domain with smaller statistical errors, remarkably increasing the precision of weak measurement under strong noise background.

Weak Measurement Amplification Based on Thermal Noise Effect

Implementation of weak measurement amplification with the weak coherent light and optomechanical system

On Amplification by Weak Measurement

Enhanced on-chip phase measurement by inverse weak value amplification

Amplification effects in optomechanics via weak measurement

Weak-value amplification of photon-number operators in the optomechanical interaction

Enhanced weak-value amplification via photon recycling

Backaction Evading and Amplification of Weak Force Signal in an Optomechanical System

Weak Value Amplification of Photons in Optical Nonlinear Medium, Opto-Mechanical, and Spin-Mechanical Systems

Amplification Limit of Weak Measurements: A Variational Approach

Amplification Limit of Weak Measurement

Measuring Small Longitudinal Phase Shifts via Weak Measurement Amplification

Auto-correlative weak-value amplification under strong noise background

Weak force sensing based on optical parametric amplification in a cavity optomechanical system coupled in series with two oscillators

Enhanced on-chip frequency measurement using weak value amplification

Weak amplification and single-photon weak-coupling optomechanics

Phase Amplification in Optical Interferometry with Weak Measurement

Toward Ultra-high Sensitivity in Weak Value Amplification

Weak value measurement with an incoherent measuring device

Beating thermal noise in a dynamic signal measurement by a nanofabricated cavity optomechanical sensor

Realization of Entanglement-Assisted Weak-Value Amplification in a Photonic System