Copper Oxide Nanoparticles Removal by Coagulation and Optimization by Matter–element Analysis Model
Yongjun Sun,Haibing Sun,Deng Li,Wenquan Sun,Huaili Zheng
DOI: https://doi.org/10.1016/j.jece.2021.107096
IF: 7.7
2021-01-01
Journal of Environmental Chemical Engineering
Abstract:Nanoparticles have been inspected in water environment and sewage treatment plants, but how to achieve efficient removal of them through existing treatment processes is a potential issue. In this study, the organic-inorganic composite coagulant (PAC-CA) was applied to remove copper oxide nanoparticles (CuO-NPs) and study their coagulation behavior and the characteristics of flocs produced by coagulation. Under the optimal coagulation conditions with a dosage of 25 mg/L, pH of 7, stirring intensity of 200 s 1, and settling time of 15 min, the removal rates of CuO-NPs and turbidity were 89.83% and 93.51%, respectively. Zeta potential studies show that the main action mechanism of PAC-CA under low dosage or alkaline conditions is charge neutralization, and under high dosage or acidic conditions, the main action mechanism is adsorption bridging. A matter-element analysis model was established based on the evaluation index of stirring intensity, kaolin concentration, humic acid concentration, initial CuO-NPs concentration, pH, PAC-CA dosage, turbidity removal rate, and CuO-NPs removal rate. Kaolin can promote the removal of CuO-NPs and turbidity by PAC-CA. The main action mechanisms of PAC-CA are charge neutralization and adsorption bridging. PAC-CA has good coagulation performance for CuO-NPs wastewater, and provides a theoretical basis for the practical engineering application of coagulation for removing nanoparticles in wastewater.