Abstract:Abstract: Novel nanostructured iron oxide-reduced graphene oxide composites were synthesized by a facile one-step hydrothermal method in an ethylene glycol (EG)–water system. Different phases of iron oxides were detected by adjusting fabrication parameters including the EG/H2O ratio, base content and iron ions concentration. Electrochemical propertyof fabricated nanocomposites as anode material was examined in a coin–type cell. The high–rate capacity and cycling stability were found, which is attributed to the improved lithium storage capability due to the application of graphene sheet acting as conductive materials for iron oxide nanoparticles. This study provides a favorable approach for exploring the nanocomposites of metal oxide-graphene anode for lithium ion battery applications. Introduction: Currently,α–Fe2O3 has been considered as a promising candidate for lithium ion batteries due to its much higher theoretical capacity of 1350 mAhg‾1 than that of commercial graphite anode materials and its environmental friendly fabrication methods from low–cost resources [1]. In particular, the use of nanomaterials is an effective path to improve rate capabilities of solid state electrodes in batteries attributed to their relatively small diffusion lengths. Furthermore,graphene, with an excellent electronic conductivity, a high theoretical surface area of 2630 m2/g and superior mechanical properties, is a significantly promising component for high performance electrode materials [2]. In this study, an anode material of iron oxide nanoparticles (mainly α–Fe2O3)–reduced graphene oxide for lithium ion battery has been synthesized and reported. Experimental: FeCl3·6H2O (1.08 g) and NaOH (0.8 g) was dissolved in EG (30 ml) by ultrasonication for 1 hour.Then 10 ml deionized water and 15 mg graphene oxide was added to the mixture under stirring to get a homogeneous solution. The solution was transferred into a 50 ml teflon–lined stainless steel autoclave, sealed and heated at 200oC for 10 hours. The product was collected by centrifuging and washed by ethanol and deionized water alternatively for several times, which was followed by drying at 80oC. Morphologies and phases of synthesized nanocomposites were characterized by scanning electron microscopy (SEM), Raman scattering spectroscopy, X-ray diffraction (XRD), high resolution transmission electron microscopy(TEM). Results: Typical XRD pattern of the products was illustrated in Fig.1 that demonstrated the co–existence of α–Fe2O3 and Fe3O4. Diffraction peaks can be indexed to either the rhombohedral phase of α-Fe2O3 (JCPDS NO.84-0307) or the cubic phase of Fe3O4 (JCPDS NO.65-3107). The characteristic peak of graphene oxide located at 10.4° was not found, confirming the formation of graphene. Fig. 1 also showed the SEM image of fabricated iron oxide nanoparticles that were uniform with the diameter about 50 nm, indicating XRD pattern in good agreement with SEM results. Raman spectra also confirmed that the typical features of reduced graphene oxide with the presence of D band (1348 cm−1) and G band (1598 cm−1). References: [1] P. C. Wang, H. P. Ding, Tursun Bark, and C. H. Chen, Electrochimica Acta,52 (2007) 6650–6655 [2] S. Stankovich, D. A. Dikin, G. H. B. Dommett, K.M. Kohlhaas, E. J. Zimney, E. A. Stach, R. D. Piner, S.T. Nguyen, and R.S. Ruoff, Nature, 442 (2006) 282–286

Nitrogen-rich carbon coupled multifunctional metal oxide/graphene nanohybrids for long-life lithium storage and efficient oxygen reduction

Facile Synthesis of Nife2o4/Reduced Graphene Oxide Hybrid with Enhanced Electrochemical Lithium Storage Performance

Oxygen-enriched carbon material for catalyzing oxygen reduction towards hybrid electrolyte Li-air battery

Nanocomposite of Iron Oxide-Reduced Graphene Oxide Applied As High-Performance Anode Materials for Lithium Ion Batteries

Multilevel Coupled Hybrids Made of Porous Cobalt Oxides and Graphene for High-Performance Lithium Storage

High-Loading Nickel Cobaltate Nanoparticles Anchored on Three-Dimensional N-Doped Graphene as an Efficient Bifunctional Catalyst for Lithium-Oxygen Batteries

Composites of Reduced Graphene Oxide and Fe 2 O 3 Nanoparticles Anchored on MoS 2 Nanosheets for Lithium Storage

Synergistic Effect of Mesoporous Co3 O4 Nanowires Confined by N-Doped Graphene Aerogel for Enhanced Lithium Storage

MFe2O4 and MFe@Oxide Core–Shell Nanoparticles Anchored on N‐Doped Graphene Sheets for Synergistically Enhancing Lithium Storage Performance and Electrocatalytic Activity for Oxygen Reduction Reactions

General Synthesis of Graphene/Metal Oxide Heterostructures for Enhanced Lithium Storage Performance

Strongly coupled hybrid ZnCo2O4 quantum dots/reduced graphene oxide with high-performance lithium storage capability

A ternary oxygen-vacancy abundant ZnMn2O4/MnCO3/nitrogen-doped reduced graphene oxide hybrid towards superior-performance lithium storage

Facile Hydrothermal Fabrication of an α-Ni(OH) 2 /N-Doped Reduced Graphene Oxide Nanohybrid as a High-Performance Anode Material for Lithium-Ion Batteries

Micro‐/Mesoporous Zinc–Manganese Oxide/Graphene Hybrids with High Specific Surface Area: A High‐Capacity, Superior‐Rate, and Ultralong‐Life Anode for Lithium Storage

Co Single Atom-Feco Alloy-Carbon Nanotube Catalysts on Graphene for Lithium-Oxygen and Lithium-Carbon Dioxide Batteries

Hierarchically Hollow and Porous NiO/NiCo 2 O 4 Nanoprisms Encapsulated in Graphene Oxide for Lithium Storage

An Efficient Multidoped Cu0.39Zn0.14Co2.47O4-ZnO Electrode Attached on Reduced Graphene Oxide and Copper Foam As Superior Lithium-Ion Battery Anodes

Hierarchical goethite nanoparticle and tin dioxide quantum dot anchored on reduced graphene oxide for long life and high rate lithium-ion storage

Hierarchically Hollow and Porous NiO/NiCo2O4 Nanoprisms Encapsulated in Graphene Oxide for Lithium Storage

Two-dimensional carbon-coated graphene/metal oxide hybrids for enhanced lithium storage.

FeOx and Si Nano-Dots As Dual Li-storage Centers Bonded with Graphene for High Performance Lithium Ion Batteries.