Abstract:Traditional timber bridges designs, while economical and durable, often have difficulty producing adequate stiffness for longer spans. Addition of FRP reinforcement has been shown to improve stiffness to a limited extent, but not nearly as much as it improves strength. To address the stiffness issue, a combined analytical/experimental pilot study is being conducted on a reinforced FRP glulam/concrete composite beam section. The section consists of a glued-laminated beam reinforced on the tension face with E-glass fiber reinforced composite. On the compression face, lag screws were driven into the wood beam before pouring the concrete slab to make the glulam beam and concrete slab composite. The stiffness of the beam was modeled using first order shear deformation theory based on available material properties. The load-deflection ratio was predicted for the limit case of a fully composite concrete slab and the limit case of no concrete slab. A nonlinear model based on moment-curvature analysis was developed and run to help quantify the increased strength and stiffness of the composite beam. An experimental program has been designed to better quantify the beam response and determine whether the strength and stiffness gained through the addition of the concrete in the compression zone sufficient to make up for the additional dead load. The wood used in the glulam was eastern hemlock, a low grade but abundant New England species. A longitudinal E-glass reinforcement mat was bonded to the wood with a phenolic adhesive through the wet lay up method. In order to control shear failure, some of the specimens were wrapped at the ends with additional E-glass shear reinforcement. To date, one beam has been loaded in three point bending within the linearly elastic range, and the results indicate that the stiffness gains are significant. Future tests will examine failure modes and the effects of shear reinforcing, as well quantifying strength gains based on economical amount of FRP reinforcing.

Performance Characterization of Wood-FRP Bonded Interfaces

Experimental Study on Dynamic Behavior of GFRP-to-concrete Interface

Experimental study on dynamic behavior of CFRP-to-steel interface

Ultimate Strength of Reinforced Concrete Beams Retrofitted with Hybrid Bonded Fiber-Reinforced Polymer

Bond-Slip Models for FPR-Concrete Interfaces Subjected to Moisture Conditions

Durability Performances of Carbon Fiber-Reinforced Polymer and Concrete-Bonded Systems under Moisture Conditions

Reliability-Based Evaluation of Flexural Members Strengthened with Externally Bonded Fiber-Reinforced Polymer Composites

Effect of Shear Resistance on Flexural Debonding Load-Carrying Capacity of RC Beams Strengthened with Externally Bonded FRP Composites

Strengthening Single-Bolt Timber Joints with Externally Bonded CFRP Composites

Fracturing behaviors of FRP-strengthened concrete structures

Effect of Frp-To-Steel Bonded Joint Configuration on Interfacial Stresses: Finite Element Investigation

Durability of Frp Concrete Bonds and Its Constituent Properties under the Influence of Moisture Conditions

Strengthening of concrete beams using fiber-reinforced platics

Experimental and 3D Numerical Study on CFRP–Concrete Interface Under Dynamic Loading

Bonding performance monitoring between CFRP and timber column interfaces based on piezoelectric ceramics

Study on flexural property of glass fiber-reinforced polymer reinforced wood–plastic composite panels

FRP-Wood-Concrete Composite Bridge Girders

EXPERIMENTAL STUDY ON FLEXIONAL BEHAVIOR OF TIMBER BEAM STRENGTHENED WITH FRP

Analytical Solution for FRP-to-concrete Bonded Joints Considering Local Unloading and Reloading

Performance Improvement of a Fiber-Reinforced Polymer Bar for a Reinforced Sea Sand and Seawater Concrete Beam in the Serviceability Limit State

Experimental and Theoretical Investigation on Shear Behaviour of Small-Scale Timber Beams Strengthened with Fiber-Reinforced Polymer Composites