Abstract:Past research has shown substantial reductions in the oxides of nitrogen (NOx) concentrations by using 10%-25% exhaust gas recirculation (EGR) in spark ignition (SI) engines (see Dudek and Sain, 1989). However, under high EGR levels, the engine exhibits strong cyclic dispersion in heat release which may lead to instability and unsatisfactory performance preventing commercial engines to operate with high EGR levels. A neural network (NN)-based output feedback controller is developed to reduce cyclic variation in the heat release under high levels of EGR even when the engine dynamics are unknown by using fuel as the control input. A separate control loop was designed for controlling EGR levels. The stability analysis of the closed-loop system is given and the boundedness of the control input is demonstrated by relaxing separation principle, persistency of excitation condition, certainty equivalence principle, and linear in the unknown parameter assumptions. Online training is used for the adaptive NN and no offline training phase is needed. This online learning feature and model-free approach is used to demonstrate the applicability of the controller on a different engine with minimal effort. Simulation results demonstrate that the cyclic dispersion is reduced significantly using the proposed controller when implemented on an engine model that has been validated experimentally. For a single cylinder research engine fitted with a modern four-valve head (Ricardo engine), experimental results at 15% EGR indicate that cyclic dispersion was reduced 33% by the controller, an improvement of fuel efficiency by 2%, and a 90% drop in NOx from stoichiometric operation without EGR was observed. Moreover, unburned hydrocarbons (uHC) drop by 6% due to NN control as compared to the uncontrolled scenario due to the drop in cyclic dispersion. Similar performance was observed with the controller on a different engine.

Controller Design and Emission Improvement for Lean-Burn CNG Engine Based on UEGO Controller

Development of the Control and Acquisition System for a Natural-Gas Spark-Ignition Engine Test Bench

Optimal control of oil-gas switch process of CNG/diesel dual fuel engine

Development and Calibration on an Electronic Control System of CNG Engine

Design of Transition State Control Method for Civil Aviation Engine Facing NOx Emission Reduction Target

Experimental Study and Model Predictive Control of a Lean-Burn Gasoline Engine Coupled With a Passive Selective Catalytic Reduction System

Influences of the Control Parameters and Spark Plug Configurations on the Performance of a Natural Gas Spark-Ignition Engine

Model-Based Control for Air-Fuel Ratio of Natural Gas Fueled SI Engines

Study on Egr Control Strategy for Vehicle Diesel Engine Based on Experiment

Sensor selection and controller design method with application to turbocharged stoichiometric spark-ignited engine controls with low pressure EGR

Development of the main controller of compressed natural gas engine based on the 32-digit powerPC561

Engine Control Design Using Globally Linearizing Control and Sliding Mode

Input Observer-Based Individual Cylinder Air-Fuel Ratio Control: Modelling, Design and Validation.

Neural network controller development and implementation for spark ignition engines with high EGR levels

Steady Condition Calibration of Turbocharged Lean Burn HCNG Engine

Impact of Excess Air Ratio and Ignition Timing on CNG Engine Emissions

Development of a Model-Based Coordinated Air-Fuel Controller for a 3.0 dm3 Diesel Engine and Its Assessment through Model-in-the-Loop

Design and Experiment of Control System for EGR Cooling System on Diesel Engine

Lean combustion and EGR with charge stratification in a spark ignition engine

Development of Diesel Engine EGR System with Autocontrolling Function

Design and Simulation of an Electronically Controlled Single-Cylinder Diesel Engine to Lower Emissions