Enhancing the vibroseis technique through equipment noise reduction and optimizing the weighted sum signal
Theresa Rademacker,Richard Miller,Jianghai Xia,Ross Black,George Tsoflias
DOI: https://doi.org/10.1190/1.2144337
2005-01-01
SEG Technical Program Expanded Abstracts
Abstract:PreviousNext No AccessSEG Technical Program Expanded Abstracts 2005Enhancing the vibroseis technique through equipment noise reduction and optimizing the weighted sum signalAuthors: Theresa RademackerRichard MillerJianghai XiaRoss BlackGeorge TsofliasTheresa RademackerKansas Geological Survey, Lawrence, KansasSearch for more papers by this author, Richard MillerKansas Geological Survey, Lawrence, KansasSearch for more papers by this author, Jianghai XiaKansas Geological Survey, Lawrence, KansasSearch for more papers by this author, Ross BlackDepartment of Geology, University of Kansas, Lawrence, KansasSearch for more papers by this author, and George TsofliasDepartment of Geology, University of Kansas, Lawrence, KansasSearch for more papers by this authorhttps://doi.org/10.1190/1.2144337 SectionsAboutPDF/ePub ToolsAdd to favoritesDownload CitationsTrack CitationsPermissions ShareFacebookTwitterLinked InRedditEmail Abstract Deconvolution of the weighted sum signal of baseplate and mass acceleration can prove marginally effective. Noise can interfere and severely limit the data quality. Identifying and reducing noise within the recording equipment has proven effective in reducing these problems. Two main sources of equipment noise are in the telemetry system commonly used for transmission and the accelerometers signal and ground force. Quantifying the noise signature and determining the degree of interference with the data is essential for deconvolving the ground force with recorded vibroseis signal.Optimizing the placement of the baseplate accelerometer yields a better representation of the source signature imparted to the earth. The baseplate accelerometer many times is located in a physically convenient location. Farfield particle motion is generally assumed to be in phase with the measured “ground force.” This is true only if the baseplate is rigid, which does not appear to always be the case at higher frequencies.Permalink: https://doi.org/10.1190/1.2144337FiguresReferencesRelatedDetailsCited ByModeling of energy transfer and parameter effects on it of a vibrator-ground system24 June 2020 | Advances in Structural Engineering, Vol. 23, No. 15Study on dynamics of vibrator baseplate at low and high frequenciesJournal of Vibroengineering, Vol. 19, No. 4The effects of inter-vibrator interference on vibrator performance22 June 2016 | Geophysical Prospecting, Vol. 64, No. 6Near‐surface utility of vibroseisRichard D. Miller, Jianghai Xia, Daniel Rice, Shelby L. Walters, and Theresa R. Rademacker14 October 2009 SEG Technical Program Expanded Abstracts 2005ISSN (print):1052-3812 ISSN (online):1949-4645Copyright: 2005 Pages: 2668 publication data© 2005 Copyright © 2005 Society of Exploration GeophysicistsPublisher:Society of Exploration Geophysicists HistoryPublished: 07 Dec 2005 CITATION INFORMATION Theresa Rademacker, Richard Miller, Jianghai Xia, Ross Black, and George Tsoflias, (2005), "Enhancing the vibroseis technique through equipment noise reduction and optimizing the weighted sum signal," SEG Technical Program Expanded Abstracts : 33-36. https://doi.org/10.1190/1.2144337 Plain-Language Summary PDF DownloadLoading ...