Abstract:A most common abnormality that affects the vertebrae is the disc prolapse. These conditions normally transpire in lumbosacral region and enmesh the spinal nerve at that point. A detoriation to the motor and sensory nerve at that point has an immediate consequence on that particular organ connected with the ascending and descending tract. Disc prolapse in thoracic region leads either to nerve root irritation or cord compression and it needs an immediate surgery to remove the disc lesion which is usually done by discectomy technique, an invasive spine surgery. However, the proposed system is to create a minimally invasive procedure to detach the disc lesion of the spine. The controlled and patient specific pre-operative planning is done by MIMIC using 3D model of the MRI of that patient. The new techniques on robotic arm like segmentation and surgical simulation will provide information about the positioning of the end effectors. Using 3D model design, the robotic arm with 3 degree of freedom is done by the SOLIDWORKS 3D CAD design software. SimMechanics is a MATLAB tool used for simulation of the physical model which gives control to the robotic arm. Furthermore, the simulation result gives the force used to produce torque at the joints and angle of joint due to torque produced. Finally, we show that the simulation in SimMechanics reduces the error occurrence in proto type construction.

Forward Kinematics Simulation for A Surgical Robot Using Catia5

Kinematic Analysis of A New Hybrid Surgical Robot

Configuration and Kinematic Analysis of a Novel Hybrid Surgical Robot with a Ball Joint

Kinematic Design of a 2DoFs Remote Center of Motion Mechanism for Minimally Invasive Surgical Robot

Kinematics analysis and trajectory planning of a multiarm medical robot assisted maxillofacial surgery

A Controller to Impose a RCM for Hands-on Robotic-Assisted Minimally Invasive Surgery

Design and Kinematic Analysis of a Parallel Robot with Remote Center of Motion for Minimally Invasive Surgery

Mechanical design and kinematic analysis of a medical robot assisted maxillofacial surgery

Kinematic analysis of a parallel robot for minimally invasive surgery

Design and Kinematic Analysis of a Robotics Maxillofacial Surgery System

Kinematics and Cooperative Control of a Robotic Spinal Surgery System

Design and Analysis of a New Remote Center-of-Motion Parallel Robot for Minimally Invasive Surgery.

Kinematics Modeling and Simulation of a Flexible Surgical Robotic Instrument with a Multi-joint Wrist

Design and Optimization of Remote Center Motion Mechanism of Minimally Invasive Surgical Robotics

Development of a 6-DOF Parallel Robot for Potential Single-Incision Laparoscopic Surgery Application

Simulation of Robotic Arm for Spinal Surgeries Engineered to Replace a Surgeon’s Tasks

Kinematic Modelling and Simulation of Six-DOF Collaborative Robot

Design of a 6-DOF Master Robot for Robot-Assisted Minimally Invasive Surgery

Experimental and numerical analysis of Novel 9 DOF Robotic Manipulator for Computed Tomography Guided Medical Procedure

Design and Kinematic Calibration of a New 4-DOF Spinal Surgery Robot

Design and Kinematic Optimization of a Two Degrees-of-Freedom Planar Remote Center of Motion Mechanism for Minimally Invasive Surgery Manipulators