Abstract:Sound propagation in shallow water is significantly influenced by geoacoustic properties. Estimating these geoacoustic parameters is essential for sound field analysis and sonar performance assessment. As a common practice, the seafloor is often treated as a single-layer or two-layer range-independent geoacoustic model to reduce the number of involved parameters. However, acoustic parameters inverted through these two geoacoustic models are typically limited in their applicability to a specific frequency range, posing challenges when applied across a broader frequency range. A range-dependent multi-layer geoacoustic model based on experimental measurements obtained with a sub-bottom profiler is proposed in this study. The inversion scheme combines three inversion methods to estimate geoacoustic parameters, considering the different sensitivities of geoacoustic parameters to different physical parameters within the acoustic field. Firstly, modal dispersion is used to invert the geoacoustic parameters of each layer, with the dispersion curve obtained through warping transform and the Wigner-Ville distribution. After that, both the localization using matched field processing and the dispersion curve fitting demonstrate the effectiveness of the inversion results for each layer, despite the peak of the probability distribution of sound speed in the first layer is broader than in others. Subsequently, matched field processing is employed to invert the geoacoustic parameters of the first layer. This method is based on the theory that as frequency increases, the depth of sound rays penetrating the seabed decreases, revealing changes in the first layer's sound speed with the seabed depth. Finally, bottom attenuation coefficients at different frequencies are inverted by the transmission loss (TL), and a fitting relationship between the attenuation coefficients and the frequencies is derived.In the discussion, the inversion results obtained using the range-dependent multi-layer geoacoustic model are compared with results estimated by the single-layer geoacoustic model. The findings indicate that the transmission loss (TL) error calculated by the range-dependent multi-layer geoacoustic model in this study is smaller than that calculated by the single-layer geoacoustic model, especially in the lower frequency band. The range-dependent multi-layer geoacoustic model proves to be suitable for a broader frequency range, providing better precision in explaining various acoustic phenomena.

Broadband Matched-Field Inversion for Shallow Water Environment Parameters

Sensitivity of Minimum Variance Matched-Field Beamforming to an Environmental Parameter Mismatch in an Uncertain Ocean Channel

Inversion of internal wave-perturbed ocean environments via acoustic data assimilation

Reflection Waveform Inversion Based on Full-Band Seismic Data Reconstruction for Salt Structure Inversion

Water Temperature Reconstruction Via Station Position Correction Method Based on Coastal Acoustic Tomography Systems.

Elastic Impedance Inversion Based on Improved Particle Swarm Optimization

Inversion of Range-Dependent Ocean Environmental Parameters Using Radiation Noises of an Autonomous Underwater Vehicle

[Algorithm of Inland Water Retrieval Based on Spectral Matching].

Inversion of shallow seabed structure and geoacoustic parameters with waveguide characteristic impedance based on Bayesian approach

Shallow water low frequency inversion on basis of range-dependent multi-layer geoacoustical model

Shear Wave Velocity Inversion Based on Scholte Waves for a Fully Saturated Seabed

Evaluation and Improvement of No-Ground-Truth Dual Band Algorithm for Shallow Water Depth Retrieval: A Case Study of a Coastal Island

A Bathymetry Mapping Approach Combining Log-Ratio and Semianalytical Models Using Four-Band Multispectral Imagery Without Ground Data

Bayesian geoacoustic parameters inversion for multi-layer seabed in shallow sea using underwater acoustic field

Inversion of Internal Wave-Perturbed Sound-Speed Field Via Acoustic Data Assimilation

Investigation of geoacoustic parameters of fine-grained sediment in the South China Sea using sequential inversion

Research on Bathymetric Inversion Capability of Different Multispectral Remote Sensing Images in Seaports

Range-dependent Geoacoustic Inversion Using Equivalent Environmental Model in the Presence of Doppler Effect.

A Passive Source Location Method in a Shallow Water Waveguide with a Single Sensor Based on Bayesian Theory

Nearshore Depth Estimation Using Fine-Resolution Remote Sensing of Ocean Surface Waves

Bottom Multi-Parameter Bayesian Inversion Based on an Acoustic Backscattering Model