Numerical Simulation on Shape Distortion of Superplastic Forming Ti-6Al-4V Cylinder
Jiang Shao-song,Lu Zhen,Li Bai-ru,Wang Guo-feng,Zhang Kai-feng
DOI: https://doi.org/10.1063/1.4806868
2013-01-01
AIP Conference Proceedings
Abstract:The dimensional accuracy and shape distortion caused by the contraction of ZG35Cr24Ni7N refractory steel die when cooling after superplastic forming were analyzed using MSC.MARC. And the influence of different processing parameters on the shape distortion was also studied. The result show that during the cooling process from 930 to room temperature, when the temperature decreases to 915 degrees C, the shape distortion begin to generate, and increasing with the reducing of the temperature up to 800 degrees C. The shape distortion increased with the rising of friction coefficient, this is because the Ti-6Al-4V cylinder can't release the volume through sliding but the plastic deformation when the friction exists. So the plastic deformation increased with the rising of friction and leading to the increase of shape distortion.
What problem does this paper attempt to address?