Abstract:Purpose: In order to mitigate motion-induced artifacts, several motion compensation (MoCo) methods have been developed, which are either able to (a) compensate for severe artifacts, but utilize the data for the reconstruction of several cardiac phases, or (b) improve image quality of a single reconstruction with only moderate motion artifacts. We propose a method combining both benefits: dose efficiency by utilizing only the data needed for a single short-scan reconstruction while still being able to compensate for severe artifacts. Methods: We introduce a MoCo method, which we call PAMoCo, to improve the visualization of the coronary arteries of a standard coronary CT angiography exam by reducing motion artifacts. As a first step, we segment a region of interest covering a chosen coronary artery. We subdivide a volume covering the whole heart into several stacks, which are sub-volumes, reconstructed from phase-correlated short-scan data acquired during different heart cycles. Motion-compensated reconstruction is performed for each stack separately, based on partial angle reconstructions, which are derived by dividing the data corresponding to the segmented stack volume into several double-overlapping sectors. We model motion along the coronary artery center line obtained from segmentation and the temporal dimension by a low-degree polynomial and create a dense 3D motion vector field (MVF). The parameters defining the MVF are estimated by optimizing an image artifact measuring cost function and we employ a semi-global optimization routine by re-initializing the optimization multiple times. The algorithm was evaluated on the basis of a phantom measurement and clinical data. For the phantom measurement an artificial vessel equipped with calcified lesions mounted on a moving robot arm was measured, where typical coronary artery motion patterns for 70 bpm and 90 bpm have been applied. For analysis, we calculated the calcified volume V inside an ROI and measured the maximum vessel diameter d based on cross-sectional views to compare the performances of standard reconstructions obtained via filtered backprojection (FBP) and PAMoCo reconstructions between 20% and 80% of the cardiac cycle. Further, the new algorithm was applied to six clinical cases of patients with heart rates between 50 bpm and 74 bpm. Standard FBP, PAMoCo reconstructions were performed and compared to best phase FBP reconstructions and another MoCo algorithm, which is based on motion artifact metrics (MAM), via visual inspection. Results: In case of the phantom measurement we found a strong dependence of V and d on the cardiac phase in case of the FBP reconstructions. When applying PAMoCo, V and d became almost constant due to a better discrimination from calcium to vessel and water background and values close to the ground truth have been derived. In the clinical study we chose reconstructions showing strong motion artifacts and observed a substantially improved delineation of the coronary arteries in PAMoCo reconstructions compared to the standard FBP reconstructions and also the MAM images, confirming the findings of the phantom measurement. Conclusions: Due to the fast reconstruction of PAMoCo images and the introduction of a new motion model, we were able to re-initialize the optimization routine at pre-selected parameter sets and thereby increase the potential of the MAM algorithm. From the phantom measurement we conclude that PAMoCo performed almost equally well in all cardiac phases and suggest applying the PAMoCo algorithm for single source systems in case of patients with high or irregular heart rates.

Motion compensated reconstructions of calcified coronary plaques in cardiac CT

Image Quality Evaluation of Motion-Contaminated Calcified Plaques in Cardiac CT

Feature-Based Characterization Of Motion-Contaminated Calcified Plaques In Cardiac Multidetector Ct

Computerized Assessment Of Motion-Contaminated Calcified Plaques In Cardiac Multidetector Ct

Investigation of Calcified Coronary Plaque Tracking in Cardiac CT

Imaging coronary plaques using 3D motion-compensated [18F]NaF PET/MR

Feature-based characterization and image quality optimization of motion-contaminated coronary structures in cardiac ct images

MO-D-I-611-05: Characterization of Motion Artifacts on CT-Reconstructed Images Using ROI-Based Features

The influence of motion-compensated reconstruction on coronary artery analysis for a dual-layer detector CT system: a dynamic phantom study

Motion compensation combining with local low rank regularization for low dose dynamic CT myocardial perfusion reconstruction

Cardiac motion compensation and resolution modeling in simultaneous PET-MR: a cardiac lesion detection study

Non-calcified Plaque-based Coronary Stenosis Grading in Contrast Enhanced CT

First in-human quantitative plaque characterization with ultra-high resolution coronary photon-counting CT angiography

Coronary Atherosclerotic Plaque Characterization with Photon-counting CT: a Simulation-based Feasibility Study

Development of physiologically‐informed computational coronary artery plaques for use in virtual imaging trials

Computer-aided assessment of cardiac computed tomographic images

Motion Tracking of Left Ventricle and Coronaries in 4D CTA.

Improved Detection of Small and Low-Density Plaques in Virtual Noncontrast Imaging-based Calcium Scoring at Photon-Counting Detector CT

Motion compensation in the region of the coronary arteries based on partial angle reconstructions from short-scan CT data

Automatic quantification and characterization of coronary atherosclerosis with computed tomography coronary angiography: cross-correlation with intravascular ultrasound virtual histology

Nonlinear registration of serial coronary CT angiography (CCTA) for assessment of changes in atherosclerotic plaque