Increase power coefficient for impeller type vertical axis wind turbine
G. Quadir,Ahmed Y. Qasim,Z. M. Zain,R. Usubamatov
Abstract:Introduction Wind power is the conversion of wind kinetic energy into a useful form, such as mechanical or electrical energy that can be harnessed for practical use by using wind turbines [1, 2]. Designing a wind turbine system that can generate power with high efficiency requires a thorough understanding of the principles of aerodynamics and structural dynamics of the rotor system. Various wind turbine mechanisms are proposed and built for capturing and converting the kinetic energy of winds. In area of the wind energy there are two main type of wind turbine , the horizontal axial and the vertical axial (Darrieus and Savonius turbines), and there are many variants of each design as well, as a number of other similar devices under development. The wind screw turbine is most commonly used in large-scale applications constituting nearly all of the turbines in the global market, while the vertical axis turbines are more commonly implemented in medium and small-scale installations. The technical characteristics of wind turbines are to be found elsewhere [3-5]. However, simple analysis of these wind turbine designs show that these designs are not perfect and the wind force does not use in full-scale wind energy due to geometrical and technical problems. Researchers state that wind turbines of lift force design theoretically have higher power efficiencies than turbines of drag force design. Other research states that at conditions of turbulent with rapid changes in wind direction practically more power will be generated by turbines of drag force design, despite its lower efficiency [2]. However, there is the following vital information: the power output of a wind generator is proportional to the acting area of wind turbines and the power output of a wind generator is proportional to the cube of the wind speed. These peculiarities should be considered as main factors of the output power to design new type of wind turbines. Hence, capturing and converting the kinetic energy of winds depends on the active area of the blades, vanes or other elements of the wind turbines and on the wind speed, which increases with altitude of the turbine location regarding the earth level. The technical characteristics of known designs of wind turbines show that there is necessity to design new type of the wind turbines without mentioned above lacks and with ability of use in wide area of application. First, new design should use the wind kinetic energy by maximum of the Betz limit [1]. The theoretical maximum power efficiency of wind turbine operates in opened atmosphere is Cp = 0.59 the Betz Limit [2]. No more than 59.3% of the available power in the wind can be extracted. No turbine to date has exceeded this limit [4]. In the world the real limit is well below the Betz Limit with values of 0.35-0.45 in the best designed wind turbines. There are other energy losses in a complete wind turbine system (the generator, bearings, power transmission, etc.) and only 10% -30% of the power of the wind is ever actually converted into usable electricity [6]. The active area of blades, vanes or other elements of the new wind turbines should give less geometrical sizes one. Presented problem can be solved by new design of the vertical axis vane type wind turbine that has simple construction, technologically simple in production, uses the drag force by active area of the working elements. The vanes of impeller type turbine are design with high drag factor to increase the efficiency and solve problems of reliable work turbine. A determination of the C drag factor is the most difficult part of this procedure. It is highly variable, and many parameters can affect on the final Cd. Shape, altitude, inclination to the wind direction, surface roughness, spin, and nose bluntness are just a few factors that can influence Cd, which can range from 0.18 up to 1.8. Tests with a cylindrical body (Flettner rotor) showed that the drag coefficient can be improved by adding disks at the top and bottom of the body; this increased the drag coefficient by 60-90%. The disks effectively change the finite cylinder into an infinite one (minus viscous losses near the disks) by ensuring 2D flow patterns. In the context of the proposed wind energy converter, it can be
Engineering,Environmental Science