Abstract:The characterization and quantification of functional groups in technical lignins are among the chief obstacles of the utilization of this highly abundant biopolymer. Although several techniques were developed for this purpose, there is still a need for quick, cost-efficient, and reliable quantification methods for lignin. In this paper, three sampling techniques for fourier transform infrared (FTIR) spectroscopy were assessed both qualitatively and quantitatively, delineating how these affected the resultant spectra. The attenuated total reflectance (ATR) of neat powders and DMSO-d6 solutions, as well as transmission FTIR using the KBr pelleting method (0.5 wt%), were investigated and compared for eight lignin samples. The ATR of neat lignins provided a quick and easy method, but the signal-to-noise ratios in the afforded spectra were limited. The ATR of the DMSO-d6 solutions was highly concentration dependent, but at a 30 wt%, acceptable signal-to-noise ratios were obtained, allowing for the lignins to be studied in the dissolved state. The KBr pelleting method gave a significant improvement in the smoothness and resolution of the resultant spectra compared to the ATR techniques. Subsequently, the content of phenolic OH groups was calculated from each FTIR mode, and the best correlation was seen between the transmission mode using KBr pellets and the ATR of the neat samples (R2 = 0.9995). Using the titration measurements, the total OH and the phenolic OH group content of the lignin samples were determined as well. These results were then compared to the FTIR results, which revealed an under-estimation of the phenolic OH groups from the non-aqueous potentiometric titration, which was likely due to the differences in the pKa between the lignin and the calibration standard 4-hydroxybenzoic acid. Further, a clear correlation was found between the lower Mn and the increased phenolic OH group content via SEC analyses. The work outlined in this paper give complementary views on the characterization and quantification of technical lignin samples via FTIR.

Modified Methods for the Analysis of the Lignin-Like Phenolic Polymer Contents of Cotton Fibers

Technology Research of Organic Weak Acid Method to Remove Lignin in the Cotton Core

A Tailored Fast Thioacidolysis Method Incorporating Multi-Reaction Monitoring Mode of GC-MS for Higher Sensitivity on Lignin Monomer Quantification

Determination of the lignin content of flax fiber with the acetyl bromide-ultraviolet visible spectrophotometry method

Comparative Study on Pigment Composition in Natural Brown Cotton Fiber and White Cottonseed Hulls

The Effect of Sample Preparation Techniques on Lignin Fourier Transform Infrared Spectroscopy

Determination of Phenolic Modified Lignin Phenolic Hydroxyl and Carboxyl Content by Non aqueous Electric Conductivity Titration

Efficient Recovery And Structural Characterization Of Lignin From Cotton Stalk Based On A Biorefinery Process Using A Gamma-Valerolactone/Water System

Four Phenolic Acids Determined by an Improved HPLC Method with a Programmed Ultraviolet Wavelength Detection and Their Relationships with Lignin Content in 13 Agricultural Residue Feeds

Free-Radical Analysis on Thermochemical Transformation of Lignin to Phenolic Compounds

A Novel Method for Determination of Aromatic Aldehyde Monomers in Lignin Degradation Liquor

Fourier Transform Infrared Spectroscopy (FT-IR) and Simple Algorithm Analysis for Rapid and Non-Destructive Assessment of Developmental Cotton Fibers

Regulation of lignin biosynthesis by GhCAD37 affects fiber quality and anther vitality in upland cotton.

A Novel Separation Technique for Cellulosic Fibers of Cotton Stalk

A Thioacidolysis Method Tailored for Higher‐throughput Quantitative Analysis of Lignin Monomers

Influence of the Lignin Extraction Methods on the Content of Tricin in Grass Lignins

Determination of lignin in Eucalyptus enriching polyphenol compounds by the acetyl bromide method

Effect of Lignin on the Measured Value of Residual Carbohydrate Content

Syntheses of lignin-derived thioacidolysis monomers and their uses as quantitation standards.

Insight into the relationship between S-lignin and fiber quality based on multiple research methods

Lignin Structure and Solvent Effects on the Selective Removal of Condensed Units and Enrichment of S-Type Lignin