Abstract:Endwall contouring technology is an effective method to improve compressor stability. The most successful endwall contouring diffuser can improve the stall margin by up to 40%. Endwall contouring improves the ability to overcome the adverse static pressure gradient for the fluid to delay the onset of rotating stall.To improve the stable operating range of centrifugal compressor stage, endwall contouring technology is introduced on the hub‐side wall of the vaned diffuser for NASA CC3 centrifugal compressor as a promising technique to redistribute the flow field near the endwall in this paper. The main contents of this paper are listed as follows. First, a specific parameterized endwall contouring guideline is developed based on sinusoidal function and Bézier curve, and three factors are considered, namely, peak height, peak radial position, and frequency coefficient. Then, centrifugal compressor stages with baseline diffuser and contoured endwall diffusers are numerically investigated to reveal the influence of endwall contouring on the stable operating range. Results show that endwall contouring is an effective method to achieve stability enhancement with no evident reduction in stage performance on the design point. CEW13‐12 has the most successful combination of endwall contouring parameters, and stall margin is increased by up to 40% for CEW13‐12. Finally, the influence mechanism of endwall contouring on the stable operating range is discussed. At the near stall condition, the contouring endwall forces the fluid within the semi vaneless space to deflect toward the suction side to increase the momentum of low‐energy fluid in the suction surface boundary layer and reduce the adverse pressure gradient on the suction side, which delay the development of flow separation on the vane leading edge near the shroud side to suppress the onset of rotating stall. At the near choke condition, the contouring endwall has more potential to increase the throat area, resulting in a decrease of throat blockage to improve choke margin. The results show that the endwall contouring technology is a reliable method to achieve stability enhancement of centrifugal compressor stage.

Investigation Of 3d Blading And Non-Axisymmetric Hub Endwall Contouring To A Dual-Stage Counter-Rotating Compressor In Multistage Environment

A throughflow-based optimization method for multi-stage axial compressor

The Effect of End Wall Boundary Layer on Matching and Corresponding Flow Control Technique for Multistage Axial Compressor

Investigation of Endwall Treatment and Shock Control in a Five-Stage Axial Compressor

Three-Dimensional Compressor Blading Design Improvements in Low-Speed Model Testing

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Investigation on Blended Blade and Endwall Technique

Three-Dimensional Aerodynamic Optimization Of A Multi-Stage Axial Compressor

Numerical Studies on Application of Blended Blade and Endwall Technique on Transonic Centrifugal Compressor

Aerodynamic Analysis and Three-Dimensional Redesign of a Multi-Stage Axial Flow Compressor

Optimization and Numerical Investigation of Combined Design of Blade and Endwall on Rotor 67

Design Optimization of the Last Stage of a 4.5-Stage Compressor Using a POD-based Hybrid Model

Investigation on Aerodynamic Performance of a Centrifugal Compressor with Leaned and Bowed 3D Blades

Optimized Aerodynamic Design of Multi-blade Rows of an Axial Compressor

Three-Dimensional Optimization of Blade Lean and Sweep for an Axial Compressor to Improve the Engine Performance

Blade-end Treatment to Improve the Performance of Axial Compressors: an Overview

Numerical Investigations on Full Blended Blade and Endwall Technique

Numerical Studies On Improving Performance Of Rotor-67 By Blended Blade And Endwall Technique

Trend of Full Three-dimensional Blading Techniques for High Performance Turbomachinery

Numerical investigation of centrifugal compressor stability enhancement using vaned diffuser endwall contouring technology