Numerical Simulation on Inertia Controlled Steam Bubble Condensation Using MPS

Daotong Chong,Yuki Ishiwatari,Yoshiaki Oka,Junjie Yan,Jiping Liu
DOI: https://doi.org/10.1063/1.4816915
2013-01-01
AIP Conference Proceedings
Abstract:Bubble dynamics is quite complicated in the field of two-phase hydrodynamics because the interfacial heat and mass transfer is comprehensively affected by various influencing factors. Bubble condensation can be either thermally controlled or inertia controlled. Inertia controlled bubble condensation indicates that considerable pressure difference exists between the steam bubble and ambient liquid. In this paper, the inertia controlled steam bubble condensation was simulated using moving particle semi-implicit (MPS) method. The spherical bubble is located in the center of the cylindrical pool which makes the possibility of 2-D axisymmetric computation. The lateral and bottom wall are set to be rigid insulated boundaries and the top is free surface boundary. The pool volume must be large enough to eliminate the effects by pool wall. The initial bubble pressure ranges from 0.48 MPa to 3.98 MPa, and the initial bubble diameter ranges from 2 mm to 5 mm, and the ambient water pressure and temperature is 0.1 MPa and 70 degrees C, respectively. The bubble dynamics during condensation was investigated and the influences of initial bubble pressure and diameter were obtained. The bubble deformation during condensation is shown in figure 1, and the variations of bubble diameters and pressures during condensation are shown in figures 2 and 3, respectively.
What problem does this paper attempt to address?