Abstract:The flow force acting on a valve disk plays an important role in the overall performance of pressure safety valves (PSVs). To quantify the disk force, computational fluid dynamics (CFD) methods have been widely implemented. In this paper, the capability of CFD models, and the identification of the most suitable turbulence models' geometry modeling and mesh requirements have been assessed to establish the accuracy of CFD models for disk force prediction. For validation purposes, a PSV disk force measuring rig was designed and constructed to obtain the steady-state flow forces exerted on the valve disk at different valve openings. The CFD model assessment is achieved by comparing the simulation results to experimental measurements; this is achieved in two stages. Stage 1 investigates the use of Reynolds averaged Navier-Stokes (RANS)-based turbulence models where two-dimensional (2D) simulations are performed with five turbulence models. The results indicate that a variety of force results are produced by different turbulence models, among which the shear stress transport (SST) k-omega was found to have the best performance. Stage 2 investigates meshing and the use of symmetry and geometry simplifications; 2D, 1/8 three-dimensional (3D) and 1/2 3D mesh models are examined. The results indicate that the 1/8 3D mesh model is the optimal choice, owing to its higher accuracy and reasonable grid scale. The studies performed in this paper extend the knowledge of compressible flow force prediction, and should facilitate the design or optimization of PSVs.

Transient Flow Analysis of Spring Loaded Pressure Safety Valve

Transient Analysis of a Spring-Loaded Pressure Safety Valve Using Computational Fluid Dynamics (CFD)

Three-Dimensional Cfd Analysis Of A Spring-Loaded Pressure Safety Valve From Opening To Re-Closure

2-D dynamic analysis of a pressure relief valve by CFD

Numerical simulation of 3-D turbulent flows in a cut-off valve and analysis of flow characteristics in pipe

Flow Forces Prediction of a Spring-loaded Pressure Safety Valve with Numerical Models

Dynamic Characteristics Analysis on High Parameter Steam Spring-Loaded Safety Valve

Transient Simulation of Valve Core Movement of Pilot-Control Globe Valve in Vertical Pipelines

A Fluid-structure Interaction Analysis of the Spring-Loaded Pressure Safety Valve During Popping Off

Cfd Analysis of the Flow Force Exerted On the Disc of a Direct-operated Pressure Safety Valve in Energy System

Numerical Analysis about the Dynamic Properties of a Pressure Relief Valve and Improvement Measures

High Fidelity Simulation of Safety Relief Valve Internal Flows

Computational Fluid Dynamics Analysis Of The Flow Force Exerted On The Disk Of A Direct-Operated Pressure Safety Valve In Energy System

DYNAMIC INSTABILITY ANALYSIS OF A SPRING -LOADED PRESSURE SAFETY VALVE CONNECTED TO A PIPE BY USING CFD METHOD

Experimental and Numerical Analysis of Spring Stiffness on Flow and Valve Core Movement in Pilot Control Globe Valve

Transient Properties of Hydraulic Operated Directional Valve Based on Fluid-structure Interaction

Flow Dynamic Analysis Inside a Sleeve Regulating Valve with Different Valve Core Shapes

CFD Analysis on the Dynamic Flow Characteristics of the Pilot-Control Globe Valve

Numerical Simulation on Fluid Dynamic Behavior of High-pressure Safety Valves

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

A CFD analysis of the dynamics of a direct-operated safety relief valve mounted on a pressure vessel