Abstract:Abstract CO2 injection is regarded as an important method for enhanced oil recovery (EOR) and greenhouse gas control by storing CO2 underground. However, the reservoir heterogeneity and low viscosity of CO2 will result in poor sweep and therefore inadequate oil recovery and inefficient gas storage. The entanglement of biopolymers is a well-known phenomenon that, when controlled, can result in a smart fluid with strong gelation properties. We have shown that when a suitable salt is incorporated into the cellulose nanocrystal (CNC), the fluids undergo gelation upon contact with bulk phase CO2 but remain a flowing liquid otherwise. In this study, we applied this composition-selective trigger to improve the sweep efficiency in CO2 EOR and sequestration. Benchtop tests were performed to observe the gelation time and strength of gel to optimize the chemical concentrations accordingly. Parameters such as CNC and salt concentrations were optimized to tune the gelation time and gel strength. The optimized CNC fluid was tested for its ability to turn to gel within the porous medium as CO2 encounters the fluid. Flow tests were performed in a representative model porous media to analyze the in-situ gelation inferred from pressure profile and fluid production. CO2 and N2 gas were used as the gas phases. A heterogeneous dual-sandpack was used to demonstrate sweep efficiency improvement during CO2 injection. Tuning the chemical concentration enabled us to optimize the gel strength and more importantly gelation time across a wide range, from 5 minutes to more than 48 hours. The gel can be easily broken in contact with nitrogen gas. After CNC+salt fluid was placed in porous media initially containing water and CO2, subsequent injection of CO2 required a very large pressure gradient to initiate flow demonstrating the in-situ generations of gel. Once the flow was initiated, subsequent sequential injections of CO2 and N2 exhibited smaller resistance to N2 than to CO2, consistent with the reversible gel/solution transition in the presence/absence of CO2 observed in batch experiments. Flow tests in heterogeneous dual-sandpack (with permeability contrast of 5) revealed that in-situ gelation diverts injected CO2 almost entirely to the lower permeability layer, which had been almost completely bypassed during injection prior to the CNC+salt injection. The composition-specific trigger, the ability to control the fluid's properties, and the renewable source of nanomaterials will open up an enormous opportunity for CO2 injection processes in heterogeneous reservoirs, in challenging locations (i.e. offshore) and in related applications such as CO2 sequestration.

A facile CO2 switchable nanocomposite with reversible transition from sol to self-healable hydrogel

CO2-Switchable Self-Healing Host–Guest Hydrogels

Responsive Polypseudorotaxane Hydrogels Triggered by a Compatible Stimulus of CO2

Self-healable hydrogels with NaHCO3 degradability and a reversible gel–sol–gel transition from phenolic ester containing polymers

CO2-switchable non-Newtonian fluids

A Sol–Gel Transition and Self-Healing Hydrogel Triggered via Photodimerization of Coumarin

Palladium-bridged polymers as CO-biosignal-responsive self-healing hydrogels

Co2-Responsive Nanofibrous Membranes with Switchable Oil/Water Wettability

Clay Nanosheet‐Based Nanocomposite Supramolecular Hydrogel Enabling Rapid, Reversible Phase Transition Only with Visible Light

Cross-linking induced thermo-responsive self-healing hydrogel with gel-sol–gel transition constructed on dynamic covalent bond

Dynamically Crosslinked Carbon Dots/biopolymer Hydrogels Exhibiting Fluorescence and Multi-Stimuli Logic-Gate Responses

Supramolecular Polymer Gel with Multi Stimuli Responsive, Self-Healing and Erasable Properties Generated by Host–guest Interactions

The Use of an Advanced Intelligent–Responsive Polymer for the Study of Dynamic Water–Carbon Dioxide Alternating Displacement

On-demand release of CO in dual-responsive nanocomposite hydrogels for wound dressing

Co2 Stimuli-Responsive, Injectable Block Copolymer Hydrogels Cross-Linked By Discrete Organoplatinum(Ii) Metallacycles Via Stepwise Post-Assembly Polymerization

CO2/N2-Switchable Thermoresponsive Ionic Liquid Copolymer

A self-healing supramolecular polymer gel with stimuli-responsiveness constructed by crown ether based molecular recognition

CO2-responsive Membranes

Dynamic Hydrogels with an Environmental Adaptive Self-Healing Ability and Dual Responsive Sol-Gel Transitions.

Construction and Function of CO<sub>2</sub>-Switchable Polymers and Composites

Cellulose Nanocrystal Switchable Gel for Improving CO2 Sweep Efficiency in Enhanced Oil Recovery and Gas Storage