Abstract:This article theoretically analyzes and conducts three-dimensional particle-in-cell simulations of mode competition in an overmoded relativistic backward wave oscillator. Based on the quality factor and coupling impedance, it achieves mode selection for a TM 02 mode backward wave oscillator, and optimizes its output power and magnetic field strength in the simulation. The quality factor is related to the group velocity and end reflection of each mode. The dispersion curves of some non-axisymmetric modes are very close, and the group velocities are basically equal. Therefore, the end reflection needs to be considered to distinguish the quality factors of different modes. In frequency domain simulation, analyzing the quality factor of each mode using the S 11 parameter curve can avoid calculating the end reflection. The three-dimensional simulation results show that the coupling impedance and quality factor jointly affect the operating mode. When the coupling impedance advantage of the working mode is not obvious, changing the resonant frequency of the high-frequency structure can affect the beam-wave interaction process, thereby changing the excitation mode. When the advantage is obvious, the beam-wave interaction of the excitation mode will not be destroyed by the resonant mode, and the output of other modes of microwave mainly comes from the conversion of the same frequency mode. Due to the constant dispersion curve, the effect of resonance on the mode is essentially the effect of the quality factor on the mode dominated by the end reflection. Using the insensitive parameters and the electron beam radius obtained from the simulation as the optimization parameters, automatic optimization algorithm was used in combination with the two-dimensional simulation to perform multi-objective optimization design in the above device. The final output power of the backward wave oscillator reached 534 MW, with an efficiency of 23.64%, an increase of 221.7% compared to the original device. The device operating mode remains stable, with the power ratio of TM 02 mode reaching 94.95%.

Influence Of Parameter Settings On The Validity Of Particle-In-Cell Simulation For A Thz Backward-Wave Oscillator

Size effect on transverse free vibrations of ultrafine nanothreads

Output Power Fluctuations Due to Different Weights of Macro Particles Used in Particle-In-Cell Simulations of Cerenkov Devices

P2-9: Parameter research in the time-dependent PIC simulation of TWTA

Parameter Calculation in Time-Dependent PIC Simulation of TWTA

Modeling Rabi Oscillation By Rigorously Solving Maxwell-Schrodinger Equation

Simulation of the Backward Wave Oscillator As a THz Radiation Source

Particles simulation of a 3 cm relativistic backward wave oscillator

Particle-in-cell simulation of field breakdown in a relativistic backward wave oscillator

Particle-in-Cell Simulation of the Impact of High-Energy Secondary Electrons on a Ka-Band TM $_{03}$ Relativistic Backward-Wave Oscillator

Nonuniform Grid Single-Field WCS FDTD Method Applied to Multithread Simulation of MIMO Dielectric Resonator Antenna

Analysis of Ohmic Loss Due to Non-Ideal Boundary in Relativistic Backward Wave Oscillator

Particle-In-Cell Simulations from a X Band Coaxial Relativistic Backward Wave Oscillator

The Study of a Coaxial Relativistic Backward Wave Oscillator by Particle-In-Cell Method

Particle-in-cell Simulation on Effect of Collector Outgassing on Relativistic Backward Oscillator

Numerical study on wave attenuation via 1D fully kinetic electromagnetic particle-in-cell simulations

A Multi-Constrained Optimization Method for THz Backward Wave Oscillators

Particle Simulation of High-Efficiency X-band Dual-Frequency Coaxial Relativistic Backward-Wave Oscillator

A Numerical Simulation Study on the Effect of Changes in Beam Parameters on Pulse Shortening in RBWOS

Research on the influence of quality factor on operating mode of TM 02 mode relativistic backwave oscillator

Objective Quantification of Mode Competition in THz BWO Optimization