Abstract:Despite the rapid development in providing precise delivery of extraneous samples to the vast majority of cells, robotic microinjection is still hindered by cumbersome operations and low throughput in practice. This study presents a new automated microinjection system equipped with two micromanipulators and a deep learning algorithm for cell identification. The introduction of two coordinated micromanipulators based on the same cell handling platform results in a large increase in injection throughput. A deep convolutional neural network, Mask R-CNN, is used to detect and segment stain-free adherent cells, leading to a considerable increase in operational efficiency and subsequent throughput. In the three independent experiments, over 10,000 MC3T3 mouse fibroblast cells are injected to evaluate the injection speed, success rate, and survival rate. Experimental results confirm that our system can inject around 4,000 cells in 1 h with an approximately 60.3% success rate and an 82.0% survival rate. This research’s success will make robotic microinjection a competitive tool in many biomedical applications, such as plasmid DNA transfection. Note to Practitioners—The motivation of this study is to improve the throughput of cell microinjection, which has become a bottleneck problem hindering the clinical application of microinjection technology. Existing cell microinjection systems typically use only one micromanipulator and rely on manual identification of cells, resulting in a limited ability to process cells for one experimental cycle. This study proposes a novel method that identifies cells through deep learning automatically and uses two micromanipulators simultaneously to improve cell processing capabilities. The problem of manipulating two micromanipulators for nearby cells is formulated as a route optimization problem, which is also suitable for three or more micromanipulators. A deep learning algorithm is used to identify and select cells to increase the processing speed. Experiments are performed to demonstrate that the proposed method can greatly increase the throughput while maintaining satisfactory performance in microinjection.

Towards Haptic Microrobotic Intracellular Injection

Haptic Microrobotic Cell Injection System

Haptic Microrobotic Intracellular Injection Assistance Using Virtual Fixtures

Haptic guidance for microrobotic intracellular injection

Intelligent Precision Control for Haptic Microrobotic Cell Injection System

Development of a Micromanipulator Robot for Cell Injection with Sub-picoliter Scale

Development and Control of A Robotic Arm for Percutaneous Surgery

Design and Assessment of a Flexure-Based 2-DOF Micromanipulator for Automatic Cell Micro-Injection

Design and Fabrication of a New Cell Microinjector Driven by Dielectric Elastomer Actuator

Assistive System for Microinjection by Presenting Cell Deformation as Surface Tactile Sensation

Intuitive Cell Manipulation Microscope System with Haptic Device for Intracytoplasmic Sperm Injection Simplification

Neuro-fuzzy microrobotic system identification for haptic intracellular injection

Precise Aspiration and Positioning Control Based on Dynamic Model Inside and Outside the Micropipette

A System For High-Speed Microinjection Of Adherent Cells

Design and Control of the 3 Axes Pneumatic Servo Micromanipulator for the Biological Technology

Low-Invasive Cell Injection based on Rotational Microrobot.

Integrated vision and force control in suspended cell injection system: Towards automatic batch biomanipulation

7-Dofs Rotation-Thrust Microrobotic Control for Low-Invasive Cell Pierce Via Impedance Compensation

A Human Microrobot Interface Based on Acoustic Manipulation.

Development, modeling, and control of a syringe-based picoliter-scale microinjection system

Deep Learning-Enhanced Dual-Module Large-Throughput Microinjection System for Adherent Cells