Abstract:Tubular hematite with high-concentration, uniform doping is regarded as a promising material for photoelectrochemical water oxidation. However, the high-temperature annealing commonly used for activating doped hematite inevitably causes deformation of the tubular structure and an increase in the trap states. In the present work, Sn-doped tubular hematite on fluorine-doped tin oxide (FTO) is successfully obtained at 750 °C from a Sn-coated FeOOH tube precursor. Sn/P codoping, which is rarely considered for hematite, is also achieved via a gas phase reaction in phosphide atmosphere. The tubular morphology allows the dopant to diffuse from both the inner and outer surfaces, thus decreasing the doping profile in the radial direction. The even distribution of Sn and P synergetically increases the carrier density of hematite by one order of magnitude, which shortens the width of the depletion layer to ca. 2.3 nm (compared with 19.3 nm for the pristine sample) and leads to prolonged carrier lifetime and efficient charge separation. In addition, this codoping protocol does not introduce additional surface trap states, as evidenced by the increased charge injection efficiency and surface kinetic analysis using intensity modulated photocurrent spectroscopy (IMPS). As a result, the morphology- and doping-engineered hematite exhibits photocurrents of 0.9 mA cm-2 at 1.23 V and 3.8 mA cm-2 at 2.0 V vs. RHE under AM 1.5 G illumination (100 mW cm-2) in 1.0 M NaOH, representing 4.5-fold and 4.8-fold enhancements, respectively, compared with the photocurrents of undoped hematite. The present method is shown to be effective for preparing multi-element-doped hematite nanotubes and may find broad application in the development of other nanotubular photoelectrodes with or without doping for efficient and robust water oxidation.

Crystallinity Engineering Of Hematite Nanorods For High-Efficiency Photoelectrochemical Water Splitting

Enhancement of Efficiency of Solar Water Splitting Based on Highly Dense Hematite Single-Crystal Nanowires

Enhanced Bulk and Interfacial Charge Transfer Dynamics for Efficient Photoelectrochemical Water Splitting: the Case of Hematite Nanorod Arrays.

Surface Engineered Doping of Hematite Nanorod Arrays for Improved Photoelectrochemical Water Splitting

Uniform Doping of Titanium in Hematite Nanorods for Efficient Photoelectrochemical Water Splitting

Nanostructured Hematite for Photoelectrochemical Water Splitting

Origin of High-Efficiency Photoelectrochemical Water Splitting on Hematite/Functional Nanohybrid Metal Oxide Overlayer Photoanode after a Low Temperature Inert Gas Annealing Treatment.

HfO 2 Functionalized Hematite Nanorods for Enhanced Photoelectrochemical Water Splitting

Engineered Hematite Mesoporous Single Crystals Drive Drastic Enhancement in Solar Water Splitting

Low- Temperature Activation of Hematite Nanowires for Photoelectrochemical Water Oxidation

Inducing Hollow and Porous Hematite Nanorod Photoanodes by Rare Earth and Transition Metal Doping for Enhanced Solar Water Splitting

Effect of Cr Doping on the Photoelectrochemical Performance of Hematite Nanorod Photoanodes

Enhancing Solar-Driven Water Splitting with Surface-Engineered Nanostructures

Enhancement of the Solar Water Splitting Efficiency Mediated by Surface Segregation in Ti-doped Hematite Nanorods

Surface Electronic Structure Reconfiguration of Hematite Nanorods for Efficient Photoanodic Water Oxidation

Doped and Core/Shell Structured Hematite Nanorods for Improved Photoanodic Performance for Solar Water Splitting

Insights into Improving Photoelectrochemical Water‐Splitting Performance Using Hematite Anode

Efficient Photoelectrochemical Water Splitting with Ultrathin Films of Hematite on Three-Dimensional Nanophotonic Structures.

Tubular Morphology Preservation and Doping Engineering of Sn/P-codoped Hematite for Photoelectrochemical Water Oxidation

Tuning Orientation of Doped Hematite Photoanodes for Enhanced Photoelectrochemical Water Oxidation

The Influence of Ti Doping on Morphology and Photoelectrochemical Properties of Hematite Grown from Aqueous Solution for Water Splitting