Abstract:Highly stable, low phase noise microwave oscillators are essential for various applications. An optoelectronic oscillator (OEO) can overcome the short-term phase noise limitation of pure electronic oscillators at high oscillation frequency. Nonetheless, the long-term frequency stability should be addressed. To stabilize the frequency of OEO, a phase-locked loop (PLL) is widely used to synchronize the OEO to a stable reference. However, due to the narrow free-spectral-range (FSR) of the oscillation cavity of the OEO, the pull-in range of the PLL is limited. It is challenging to acquire phase-locking at startup and phase-relocking when mode-hopping of OEO occurs. Here, by using an automatic frequency calibration (AFC) assisted PLL, we attain a highly stable 10 GHz phase-locked OEO with robust phase-locking at startup and phase-relocking when mode-hopping of OEO occurs, for the first time. With the use of a fast digitally-controlled frequency shifter and a real-time frequency error detection unit in the AFC loop, the phase-locking and phase-relocking time are below 120 ms. Furthermore, it shows the phase noise of -135 dBc/Hz at 10 kHz offset, side-mode suppression ratio (SMSR) of 128 dBc, and Allan deviation of 4.8×10-11 at 5000 s for the phase-locked OEO. We thoroughly investigate the dynamics of the automatic frequency calibration, the phase-locking process, the phase-relocking after OEO mode-hopping, the system under vibration, and the frequency switching. Our approach is promising to generate a highly stable, low phase noise, and determinate frequency microwave signal, which can be used as a low phase noise reference for a microwave frequency synthesizer and high performance sampling clock for a data conversion system.

Development of High Frequency-Temperature Stability of OCXO for Aerospace Applications

Study of Wavelength Temperature Stability of Multifunctional Integrated Optical Chips Applied on Fiber Optic Gyroscopes

A Frequency-Stable Optoelectronic Oscillator Based on Passive Phase Compensation

Design of a New Analog TCXO with High Frequency Stability

Simulation and Demonstration for the Thermoelectric Cooler to Improve Warm-up Time of OCXO

Frequency Stabilization of an Optoelectronic Oscillator Based on Phase-Locked-Loop

A CMOS Relaxation Oscillator with Process and Temperature Variation Compensation.

A Ka-Band Class-C BiCMOS VCO with Temperature Compensation

Temperature Sensing and Control to Improve Warm-up Time of OCXOs

A 0.1 ppm Successive Approximation Frequency-Temperature Compensation Method for Temperature Compensated Crystal Oscillators (TCXO)

A Method to Increase the Frequency Stability of a TCXO by Compensating Thermal Hysteresis

Design of frequency calibration and test system for high-precision TCXO

A Digital-Analog Mixed Temperature Compensated Crystal Oscillator with 1.8v/0.18&#x03bc;m Mix-Signal CMOS Process

Frequency Stability Optimization of an OEO Using Phase-Locked-loop and Self-Injection-locking

A Chip-Scale Atomic Resonator-Based Stabilization System for Optoelectronic Oscillator

Design of TCXO Chip with High Accuracy and Wide Temperature Range

The Oven Controlled MEMS Oscillators in Timing and Sensing Applications: A review

A High-Precision Mixed-Signal Voltage-Controlled Crystal Oscillator with Temperature Compensation

Adaptive correction algorithm for high precision time maintenance of OCXO

A 0.72nw, 0.006mm2 32khz Crystal Oscillator with Adaptive Sub-Harmonic Pulse Injection from −40°C to 125°C in 22nm FDSOI

Fast automatic frequency calibration assisted phase-locked highly stable optoelectronic oscillator