Acoustic Emission Characteristics of Rock under Impact Loading

Xi-ling Liu,Xi-bing Li,Liang Hong,Tu-bing Yin,Meng Rao
DOI: https://doi.org/10.1007/s11771-015-2897-8
2015-01-01
Journal of Central South University
Abstract:Acoustic emission tests were performed using a split Hopkinson pressure bar system (SHPB) on 50-mm-diameter bars of granite, limestone, sandstone and skarn. The results show that the amplitude distribution of hits is not well centralized around 50 dB, and that some hits with large amplitudes, usually larger than 70 dB, occur in the early stages of each test, which is different from the findings from static and low-loading-rate tests. Furthermore, the dominant frequency range of the recorded acoustic emission waveforms is between 300 kHz and 500 kHz, and frequency components higher than 500 kHz are not significant. The hit with the largest values of amplitude, counts, signal strength, and absolute energy in each test, displays a waveform with similar frequency characteristics and greater correlation with the waveform obtained from the elastic input bar of the split Hopkinson pressure bar system compared with the waveforms of the other hits. This indicates that the hit with the largest values of amplitude, counts, signal strength, and absolute energy is generated by elastic wave propagation instead of fracture within the rock specimen.
What problem does this paper attempt to address?