Abstract:Due to the complex and variable nature of the atmospheric conditions, traditional multi-wavelength differential absorption lidar (DIAL) methods often suffer from significant errors when inverting ozone concentrations. As the detection range increases, there is a higher demand for Signal to Noise Ratio (SNR) in lidar signals. Based on this, the paper discusses the impact of different atmospheric factors on the accuracy of ozone concentration inversion. It also compares the advantages and disadvantages of the two-wavelength differential method and the three-wavelength dual-differential method under both noisy and noise-free conditions. Firstly, the errors caused by air molecular extinction, aerosol extinction, and backscatter terms in the inversion using the two-wavelength differential method were simulated. Secondly, the corrected inversion errors were obtained through direct correction and the introduction of a three-wavelength dual differential correction. Finally, addressing the issue of insufficient SNR in practical inversions, the inversion errors of the two correction methods were simulated by constructing lidar parameters and incorporating appropriate noise. The results indicate that the traditional two-wavelength differential algorithm is significantly affected by aerosols, making it more sensitive to aerosol concentration and structural changes. On the other hand, the three-wavelength dual differential algorithm requires a higher SNR in lidar signals. Therefore, we propose a novel strategy for inverting atmospheric ozone concentration, which prioritizes the use of the three-wavelength dual-differential method in regions with high SNR and high aerosol concentration. Conversely, the direct correction method utilizing the two-wavelength differential approach is used. This approach holds the potential for high-precision ozone concentration profile inversion under different atmospheric conditions.

A numerical inversion method for CCD side-scatter lidar

A New Method for a Side-Scattering Lidar to Retrieve the Aerosol Backscattering Coefficient

New Technique for Aerosol Detection in Haze Day Using Side‐Scattering Lidar and Its Inversion Method

Measurements of aerosol phase function and vertical backscattering coefficient using a charge-coupled device side-scatter lidar

Pattern Recognition Model for Aerosol Classification with Atmospheric Backscatter Lidars: Principles and Simulations

Retrieval and Analysis of a Polarized High-Spectral-resolution Lidar for Profiling Aerosol Optical Properties

Development and case study of side-scatter lidar system based on charge-coupled device

Software Design Of Control System Of Ccd Side-Scatter Lidar

New experimental method for lidar overlap factor using a CCD side-scatter technique.

Research on the Application of Lidar Extinction Coefficient Inversion Method

The application of measuring atmospheric properties in overlap factor region using scanning Lidar

Retrieval method of aerosol extinction coefficient profile by an integral lidar system and case study

Detecting Aerosol Backscattering Coefficient Across the Whole Troposphere by the Sidescattering Lidar System with Three CCD Cameras

A New Approach to Inverting Backscatter and Extinction from Photon-Limited Lidar Observations

Subspace-based Optimization Method Coupled with Multiplicative Regularization for Edge-Preserving Inversion

Retrieving aerosol backscattering coefficient for short range lidar using parameter selection at reference point

Uncertainty Factors of Aerosol Optical Properties Inversion by Lidar

A System Design Of Data Acquisition And Processing For Side-Scatter Lidar

Experimental Determination of Dual-Wavelength Mie Lidar Geometric Form Factor Combining Side-Scatter and Back-Scatter Signals

Research on the Correction Algorithm for Ozone Inversion in Differential absorption Lidar

Multi-Wavelength Fitting Simulation and Inversion of Atmospheric Aerosol Spectrum Distribution