An integrated manufacturing system for rapid tooling based on rapid prototyping
Yucheng Ding,Hongbo Lan,Jun Hong,Dianliang Wu
DOI: https://doi.org/10.1016/j.rcim.2003.10.010
IF: 10.103
2004-01-01
Robotics and Computer-Integrated Manufacturing
Abstract:To reduce the time and cost of moulds fabrication, a novel integrated developing and manufacturing system of rapid tooling (RT) based on rapid prototyping (RP) is proposed. The architecture of system which consists of four building blocks: digital prototype, virtual prototype (VP), physical prototype and RT system, is presented. A digital prototype can be established by 3D CAD software packages or reveres engineering technique. A VP is employed to guide in optimization of the mould design and manufacturing process planning. A physical prototype, which is built using RP technology, generally serves as a pattern for producing RT. By integrating these building blocks closely, the system can aid effectively in mould design, analysis, prototyping, simulating, and manufacturing process development. Three typical cases are discussed in detail to illustrate the application of the system. It has been shown from a number of case studies that the system has a high potential to reduce further the cycle and cost of die development while minimizing error introduction. As a result, the integrated system provides a feasible and useful tool for companies to speed up their product development.