Removal of lead(II) from aqueous solutions by activated carbon developed from surplus sludge

Zhu-wu Jiang,Xue-jiang Wang,Xue Ning

DOI: https://doi.org/10.1007/s11771-014-2337-1

2014-01-01

Journal of Central South University

Abstract:Activated carbon (AC) was prepared from surplus sludge using chemical activation method with the assistance of ZnCl 2 . The influences of process parameters on the AC’s specific surface area and adsorption capacity for Pb 2+ were examined to optimize these parameters. The optimal conditions for the preparation of AC were determined to be activation temperature of 500 °C, activation time of 1 h, impregnation ratio of 1:1 (solid-to-liquid volume) with the 30% ZnCl 2 solution (mass fraction), giving the BET surface area of 393.85 m 2 /g and yield of 30.14% with 33.45% ash. Also, the pyrolysis temperature was found to be the most important parameter in chemical activation. FTIR spectra provided the evidence of some surface structures such as C=C and C-O-C. In the adsorption studies, a rise in solution pH led to a significant increase in adsorption capacity when the pH value varied from 3.0 to 7.0, and the optimal pH for removal of Pb 2+ was 7.0. It was observed that the pseudo-second-order equation provided better correlation for the adsorption rate than the pseudo-first-order and the Langmuir model fitted better than the Freundlich model for adsorption isotherm. The adsorption capacity of AC to Pb 2+ was 11.75 mg/L at solution pH 7.0, the equilibrium time 480 min and 25 °C. Moreover, the adsorption process is endothermic according to the value of enthalpy change.