Abstract:The need for environmental friendly and sustainable energy conversion has triggered renewed interest into the electrochemical and photoelectrochemical splitting of water. A key challenge in this field is the development of economically viable electrocatalyst materials for the oxygen evolution reaction (OER). Transition-metal oxide catalysts, in particular the cobalt (hydr)oxide materials, have been found as promising candidates, since they are earth-abundant, efficient and scalable over a wide range of electrochemical conditions [1]. They present good catalytic properties and stability in alkaline solution under ambient conditions. Although a wide variety of different catalysts with rather diverse nanoscale morphologies have been synthesized and studied, the atomic scale surface structure usually is still unknown or poorly defined. This makes it difficult to compare their electrocatalytic activity and correlate it with ab initio theoretical studies, which hinders the development of clear structure-reactivity relationships and unambiguous determination of the OER reaction mechanism. We presentsystematic comparative studiesof structurally well-defined, 18-35nm thick Co 3 O 4 films, prepared by electrodeposition or physical vapor deposition (PVD) on Au(111), Au(100) and Ir(100) single crystals. In all cases a well ordered epitaxial Co 3 O 4 (111) arrangement results, but the film morphology differs substantially, as shown by AFM and surface X-ray diffraction (SXRD). In order to elucidate the quantitative relationship between the catalyst surface structure and the OER reactivity, synchrotron-based operando SXRD and electrochemical measurements were performed simultaneously under reaction conditions, using a dedicated operando cell which allows massive gas evolution and current densities of up to 150 mA/cm 2 [2,3]. We find that the Co 3 O 4 (111) layers prepared by PVD on Ir(100) stay perfectly stable in the pre-OER and OER potential regime, whereas all electrodeposited films exhibit reversible changes in the oxide structure and oxidation state, in agreement with a previous study of Co 3 O 4 catalysts [2]. Specifically, we observe the reverse formation of an ultrathin X-ray-amorphous CoO x (OH) y skin layer above 1 V vs. RHE and the gradual buildup of tensile lattice strain in the underneath, remaining Co 3 O 4 layer with increasing potential. These structural changes occur for all electrodeposited samples, albeit to a different extent, depending on the film morphology [3]. Studying the relationship between the effective thickness of this skin layer and the OER reactivity, we found clear evidence that the entire skin layer is a three dimensional OER zone, which strongly exceeds one monolayer. Our results suggest that even subtle changes of the surface morphology have large influence on the OER activity of the Co 3 O 4 catalyst, which may be expected also for other spinel-type transition metal oxides. On the one hand, this reveals that great care as to be taken in comparing the OER activity of differently prepared catalysts. On the other hand, these observations may provide a base for targeted preparation of highly reactive oxide catalysts. [1] C. C. L. McCrory et al., Journal of the American Chemical Society 2015, 137, 4347. [2] F. Reikowski, et al., ACS Catalysis, 2019, 9, 3811. [3] T. Wiegmann, et al., ACS Catalysis, 2022, 12, 256.

An ab initio thermodynamics study of cobalt surface phases under ethanol steam reforming conditions

Synchrotron Radiation in Situ X-ray Absorption Fine Structure and in Situ X-ray Diffraction Analysis of a High-Performance Cobalt Catalyst Towards the Oxygen Reduction Reaction

Theoretical investigation of the adsorbate and potential‐induced stability of Cu facets during electrochemical CO2 and CO reduction

Electron density donation of concomitant peroxide anions in La0.25Ce0.75O1.88 boosting cobalt-catalyzed ethanol steam reforming for hydrogen production

Regulating cobalt chemical state by CeO2 facets preferred exposure for improved ethanol steam reforming

Experimental research on acetic acid steam reforming over Co-Fe catalysts and subsequent density functional theory studies

DFT+U Study of the Electronic, Magnetic and Mechanical Properties of Co, CoO, and Co3O4

Atomic-scale understanding of the impact of CoO phase in cobalt-catalyzed fischer-tropsch synthesis: A combined computational and experimental study

Theoretical Studies of CO Oxidation with Lattice Oxygen on Co3O4 Surfaces

Understanding the Dynamic Evolution of Atomically Dispersed Cu Catalyst for CO 2 Electrochemical Conversion Using Integrated XANES Analysis and Mechanistic Studies

The surface structure, stability, and catalytic performances toward O2 reduction of CoP and FeCoP2

Carbon Monoxide Activation on Cobalt Carbide for Fischer–Tropsch Synthesis from First-Principles Theory

Surface oxidation/spin state determines oxygen evolution reaction activity of cobalt-based catalysts in acidic environment

New Insights into Reaction Mechanisms of Ethanol Steam Reforming on Co–ZrO2

Stability of Carbon on Cobalt Surfaces in Fischer–Tropsch Reaction Conditions: A DFT Study

CO2 Activation on Cobalt Surface in the Presence of H2O: An Ambient-Pressure X-ray Photoelectron Spectroscopy Study

Operando Surface X-Ray Diffraction Studies of Co Oxide Catalyst Films for Electrochemical Water Splitting

Size effects and active state formation of cobalt oxide nanoparticles during the oxygen evolution reaction

CO2 Thermoreduction to Methanol on the MoS2 Supported Single Co Atom Catalyst: A DFT Study

Dynamics of Co/Co2C redox cycle and their catalytic consequences in Fischer–Tropsch synthesis on cobalt–manganese catalysts