Abstract:High-accuracy servo control of pneumatic systems requires nonlinear model-based control techniques based on full-state knowledge of the system.For the consideration of cost or light-weight design,non-linear pressure observers in place of pressure sensors were constructed to acquire the pressure states in the chambers of the pneumatic cylinder.Firstly,the global stability of the proposed pressure observer was demonstrated based on Lyapunov-stability theory.Secondly,the pressure observer's polytropic exponent was analyzed and determined experimentally.Moreover,to check the fast convergence of the proposed pressure observer,a set of experiments for tracking a 0.5 Hz sinusoidal trajectory were performed under condition that the initial states of both chambers should be pressurized and the initial values of the observed pressures were intentionally set different from the actual values.Furthermore,to verify the load-independent of the presented pressure observer,the valve-controlled pneumatic cylinder system acted upon by a variable-stiffness loading force was adopted to carry out pneumatic servo control.A three-way on-off solenoid value was configured as two-way valve.Thus,four two-way on-off solenoid valves controlled with pulse width modulation (PWM) in lieu of one or two proportional valves were employed to govern the pneumatic cylinder for achieving the pneumatic servo control.Finally,extensive experiments validated the effectiveness and feasibility of the proposed pressure observer for high-accuracy pneumatic servo control of the valve-controlled pneumatic cylinder system.

Finite-time state observer design for a pneumatic servo system

Globally Stable, Fast Convergent and Load-independent Pressure Observer for Pneumatic Servo Systems

Finite-time Output Feedback Control for a Pneumatic Servo System

Parallel Velocity Control of an Electro-Hydraulic Actuator with Dual Disturbance Observers

Controller and Observer Design for Lipschitz Nonlinear Systems

Adaptive Controller and Observer Design for A Class of Nonlinear Systems

Finite-time Extended State Observer Based Fault Tolerant Output Feedback Control for Attitude Stabilization

Position Tracking Control for Pneumatic Servo System Subject to State Constraints and Voltage Saturation

Position controller for servo systems based on state observer and feedback

The Analysis And Design Of Low Velocity Estimation Based On Observer

Continuous Finite-Time Attitude Control for Rigid Spacecraft Based on Angular Velocity Observer

Finite-Time Output Feedback Control for a Rigid Hydraulic Manipulator System

High-Order Fully Actuated Control Approach for Servo Systems Based on Dynamical Compensator and Extended State Observer

State and Disturbance Observer-Based Controller Design for Fully Actuated Systems

Event-Triggered Adaptive Fuzzy Output Feedback Tracking Control for Pneumatic Servo System with Input Voltage Saturation and Position Constraint

Dimensionality Reduction Observer Design Based on Position Servocontrol System

Observer-Based Output Feedback Attitude Stabilization for Spacecraft with Finite-Time Convergence

Finite-time Control for Permanent Magnet Synchronous Motor Speed Servo System Via a Disturbance Observer.

Control for a Class of Stochastic Mechanical Systems Based on the Discrete-Time Approximate Observer

Observer-based Stabilization of One-Sided Lipschitz Systems with Application to Flexible Link Manipulator

Active disturbance rejection control for a pneumatic motion platform subject to actuator saturation: An extended state observer approach.