Abstract:Reflection and transmission (R/T) responses characterize the propagation and energy distribution of incident and reflected waves on both sides of an interface which is crucial for imaging, amplitude variation with offset (AVO), and seismic inversion techniques. Subsurface media are typically characterized by anisotropy which can have a significant impact on the R/T response, even at small incident angles. Currently, anisotropic media problems including reflection, transmission, and inversion are generally discussed under a weak anisotropy assumption. However, this assumption is no longer valid in cases of large angles where anisotropy enhancement exacerbates the error of the conventional R/T coefficient approximation. An R/T coefficient approximation method for strong VTI media was proposed based on the assumption of weak-contrast of the media. In contrast to the conventional approach, which simplifies the phase velocity and polarization in an anisotropic background, the phase velocity and polarization at the weak-contrast interface of the elasticity and anisotropy parameters were approximated using a combination of the anisotropic background and perturbation terms. Specifically, a first-order approximation of the R/T coefficients for the VTI media characterized by elastic and anisotropic parameters was derived using Cramer's law to invert the anisotropic background matrix, avoiding the assumption of weak anisotropy. Subsequently, the exact solution of the Zoeppritz equations was used to correct the isotropic part, improving the accuracy of the R/T coefficients at interfaces with high-velocity contrast. Modeling tests on four classes of typical interfaces showed that the derived equations can be degraded to the Aki approximation in isotropic media, while exhibiting high accuracy in strong VTI media. Uncertainty analyses showed that a linear approximation that facilitates seismic inversion can be obtained by taking the S- to P-velocity ratio and anisotropy parameters in the coefficient terms a priori.

Exact Elastic Impedance in Orthorhombic Media

A relative impedance variation imaging of pre-stack seismic reflection data based on reflection wave equation

Elastic Impedance Equation Based on the Incident-angle Approximation and Inversion

Effective and Efficient Approaches for Calculating Seismic Ray Velocity and Attenuation in Viscoelastic Anisotropic Media

An Approximate Acoustic Wave Equation for VTI Media

Characteristics of orthorhombic anisotropic seismic response induced by horizontal in situ stress in vertical transversely isotropic media

Estimation of Elastic Parameters Using Two-Term Fatti Elastic Impedance Inversion

An improved pure quasi-P-wave equation for complex anisotropic media

Seismic Characterization of Fractured Reservoirs with Elastic Impedance Difference Versus Angle and Azimuth: A Low-Frequency Poroelasticity Perspective

Reflection and transmission coefficient approximation at weak-contrast interfaces for strong VTI media

Characterization and analysis of attenuation anisotropy in viscoelastic vertical transverse isotropic media

Accuracy Comparison Of Elastic Impedance Formula

Shear Wave Velocity Estimation in HTI Media

On the azimuthal dependence of orthorhombic fractures for vertical seismic profiles using the ellipsoidal approximation

Anisotropy Parameters Estimation in Stress-Induced Orthorhombic Reservoirs Based on Step-Wise Bayesian Inversion of Azimuthal Seismic Data

Investigation of Amplitude Accuracy for Pseudo-acoustic Wave Propagation in Azimuthal Anisotropic Media

Seismic AVA Inversion of Elastic and Attenuative Parameters in Viscoelastic Media Using the Zoeppritz Equations

Separating Quasi-P-Wave in Transversely Isotropic Media with A Vertical Symmetry Axis by Synthesized Pressure Applied to Ocean-Bottom Seismic Data Elastic Reverse Time Migration

Estimation of Quality Factor Q from the Instantaneous Frequency at the Envelope Peak of A Seismic Signal

Estimation of Brittleness and Anisotropy Parameters in Transversely Isotropic Media with Vertical Axis of Symmetry

Estimation of Anisotropy Parameters for a Clay-rich Shale Formation Based on a Rock Physics Model