Abstract:Dielectric elastomer(DE) is a kind of promising material bearing excellent activate properties including large deformations (up to 380%), high energy densities (up to 3.4 J/g), high efficiency, high responsive speed, good reliability and durability. Thus the DE actuator, sensors and energy harvester is widely used in the field of aeronautics and smart bionics. When an electric field is applied on the compliant electrodes of the dielectric elastomers, the polymer shrinks along the electric field and expands in the transverse plane. In consequence, the electric field becomes higher. This kind of positive feedback may cause the elastomer to thin down, resulting in an electromechanical stability. An analysis on the electromechanical stability of dielectric elastomer using arbitrary free-energy function with constant dielectric constant has been presented in Suo’s papers. In many research on the electromechanical stability analysis of DE actuator, DE’s dielectric constant is assumed to be a constant. This is only the truth if the dielectric elastomer undergoing limited deformation. Actually, a typical dielectric elastomer is a kind of crosslinked polymer. The structural symmetry of the macromolecular, the crosslinking degree, along with the tensile deformation can affect the dielectric permittivity enormously. For dielectric elastomers with higher crosslinking degree, or higher degree of molecular structural symmetry, its permittivity is relatively low. In addition, stretching can guide the macromolecule to be arranged in order, this can increase the intermolecular forces and reduce the activities of polar group, as a results, the dielectric constant will decrease. However, if the crosslinking degree is low and the deformation is well below the extension limit, the molecular units in the polymers can be polarized as freely as in a polymeric liquid. In this case the corresponding permittivity is unaffected by the deformation. Recent experimental research results also proved that the dielectric permittivity of dielectric elastomer changed while undergoing large deformation. According to Pelrine, the dielectric constant of the DE film is variable and it is a function of the area increase ratio which depends on stretch ratio. In this paper, approach for the electromechanical stability of a dielectric elastomer having variable dielectric constant is developed. The critical breakdown electric field is obtained. Simulation results proved that the prestretching process can enhance remarkably the electromechanical stability of dielectric elastomer. These results agree well with the experimental data and can be used as guidances in the design and fabrication of dielectric elastomer actuators.

Effect of temperature on the electric breakdown strength of dielectric elastomer

Electromechanical Stability Of Dielectric Elastomer Using Electric Energy Density Function With Variable Dielectric Constant

The Temperature-Dependent Viscoelastic Behavior of Dielectric Elastomers

Mechanisms of large actuation strain in dielectric elastomers

Electromechanical Behavior Of Fiber-Reinforced Dielectric Elastomer Membrane

Theory analysis method for the effect of temperature and electrostrictive on the actuation stability of dielectric elastomers

Thermo-electro-mechanical instability of dielectric elastomers

Giant voltage-induced deformation in dielectric elastomers near the verge of snap-through instability

Self‐Strengthening Dielectric Elastomer of Triblock Copolymer with Significantly Improved Electromechanical Performance under Low Voltage

Significantly improved electromechanical performance of dielectric elastomers via alkyl side-chain engineering

Tunable Actuation of Dielectric Elastomer by Electromechanical Loading Rates

Humidity effect on electromechanical breakdown of dielectric elastomers subject to a ramp voltage

Giant, Voltage-Actuated Deformation of a Dielectric Elastomer under Dead Load

Mechanics of Dielectric Elastomers: Materials, Structures, and Devices

The Behavior of Dielectric Elastomer Actuators Connected in Series and Parallel

Suppression of Electromechanical Instability in Fiber-Reinforced Dielectric Elastomers

Thermoplastic Dielectric Elastomer of Triblock Copolymer with High Electromechanical Performance.

Modeling of temperature effect on electromechanical properties of dielectric elastomer minimum energy structures

Effect of temperature and pre-stretch on the dynamic performance of dielectric elastomer minimum energy structure

A Thermo-Electro-Viscoelastic Model for Dielectric Elastomers

Thermoelectromechanical instability of dielectric elastomer undergoes polarization saturation and temperature variation