Abstract:This study aims to study the damage evolution characteristics of rock mass containing prefabricated cracks with different angles. First, similar material proportioning tests were carried out referring to the composition and mechanical properties of coal seam roof in Xin-ji No. 1 Coal Mine based on the analog simulation theory. Afterwards, macroscopic cracks with different angles were prefabricated on the specimens. During the uniaxial loading experiments, the infrared radiation information of the specimen surface was obtained using an infrared monitoring system. Moreover, the damage variables were defined based on the accumulated infrared radiation temperature and the proportion of dissipative strain energy in the energy evolution. The results show that with the increase in prefabricated crack’s dip angle, the brittleness of the rock mass diminishes; the closing strain of the prefabricated crack decreases; the stress concentration location of the crack tip starts to spread outward from the center of the specimen; and the failure changes from a tensile-shear composite mode to a tensile splitting mode. The infrared radiation temperature on the specimen surface fluctuates; specifically, it falls first and then rises. The abrupt change of the maximum infrared radiation temperature near the peak stress is significant, and this change reaches the maximum when the dip angle of the prefabricated crack is 45°. In addition, the damage evolution process of the rock mass can be roughly divided into three phases: initial damage, stable damage and accelerated damage. The stresses calculated from the defined damage variables have the same trend with the measured stresses, with a correlation of over 0.9, so it can well characterize the progressive evolution process from the crack emergence, expansion to failure. The research presented in this paper can provide a theoretical support for the early warning of coal-rock dynamic disaster.

Radon emission evolution and rock failure

A Quantitative Criterion to Describe the Deformation Process of Rock Sample Subjected to Uniaxial Compression: from Criticality to Final Failure

Analysis on the Critical Electromagnetic Emission During Coal or Rock Fracture

Permeability Evolution and Rock Brittle Failure

Experimental study on infrared radiation and crack evolution characteristics during the failure process of rocks with pre-set crack

Wave Velocity and Stress/strain in Rock Brittle Failure

Pore Structure Evolution and Radon Exhalation Characteristics of Sandstone after Loading and Unloading

Study on the Critical Stress State of Brittle Failure of Rock Based on Renormalization Group Theory

Robustness of Rock Damage Regions Induced by Crack Nucleation

Damage evolution of rock containing prefabricated cracks based on infrared radiation and energy dissipation

Analysis of Critical Acoustic Emission Information of Sandstone Brittle Failure with Stress Ratio

Investigation of Microcrack Propagation and Energy Evolution in Brittle Rocks Based on the Voronoi Model

Study on Electromagnetic Radiation in Crack Propagation Produced by Fracture of Rocks

Experimental investigation of the strain rate effect on crack initiation and crack damage thresholds of hard rock under quasi-static compression

A Study on Crack Damage Stress Thresholds of Different Rock Types Based on Uniaxial Compression Tests

Study on the evolution law and quantitative characterization of micro-crack propagation in the compressive failure process of rocks

Numerical statistical analysis on self-organizing behavior of microfracturing events in rock failure

Study on multi-scale damage and failure mechanism of rock fracture penetration: experimental and numerical analysis

Failure prediction from crack evolution and acoustic emission characteristics of coal-rock sandwich composite samples under uniaxial compression

Linear fractal evolution characteristics of rock crack distributions during loading process

Study on Microcrack Propagation and Evolution of Fractured Coal-Rock Based on Mineral Particle Model