EFFECTS OF CHEMICAL DISPERSANT ON OIL SEDIMENTATION DUE TO OIL-SPM FLOCCULATION: EXPERIMENTS WITH THE NIST STANDARD REFERENCE MATERIAL 1941?

Ali Khelifa,Ben Fieldhouse,Zhendi Wang,Chun Yang,Mike Landriault,Carl E. Brown,Merv Fingas

DOI: https://doi.org/10.7901/2169-3358-2008-1-627

2008-01-01

Abstract:ABSTRACT As it is well established that application of chemical dispersant to oil slicks enhances the concentration of oil droplets and reduces their size, chemical dispersants are expected to enhance oil sedimentation if applied in coastal waters rich in suspended particulate matter (SPM) and if flocculation between chemically dispersed oil and SPM, which leads to formation of oil-SPM aggregates (OSAs), occurs readily. New laboratory experiments were conducted to establish a quantitative understanding of the process and to verify this hypothesis. This paper presents findings from experiments conducted using Standard Reference Material 1941b prepared by the National Institute of Standards and Technology, Arabian Medium, Alaska North Slope and South Louisiana crude oils, and Corexit 9500 and Corexit 9527 chemical dispersants. Results showed that OSAs do form with chemically dispersed oil. Oil sedimentation increases with sediment concentration and reach a maximum at a sediment-to-oil ratio of approximately 2:1 for most of the oils used. No obvious effect of chemical dispersant on oil sedimentation was measured for sediment concentration of 100 mg/L and higher. However, measured oil sedimentation was 3 to 5 times higher with chemical dispersant than with physically dispersed oil at low sediment concentration of 25 and 50 mg/L. UV epi-fluorescence microscopy showed that OSAs formed with chemically dispersed oil contain many oil droplets that are smaller than those trapped in OSAs formed with physically dispersed oil.