Abstract:Implementation of spray-guided stratified-charge direct-injection spark-ignited (DISI) engines is inhibited by the occurrence of misfire and partial burns. Engine-performance tests demonstrate that increasing engine speed induces combustion instability, but this deterioration can be prevented by generating swirling flow during the intake stroke. In-cylinder pressure-based heat-release analysis reveals that the appearance of poor-burn cycles is not solely dependent on the variability of early flame-kernel growth. Cycles can experience burning-rate regression during later combustion stages and may or may not recover before the end of the cycle. Thermodynamic analysis and optical diagnostics are used here to clarify why swirl improves the combustion repeatability from cycle to cycle.The fluid dynamics of swirl spray interaction was previously demonstrated using high-speed PIV measurements of in-cylinder motored flow. It was found that the sprays of the multi-hole injector redistribute the intake-generated swirl flow momentum, thereby creating a better-centered higher angular momentum vortex with reduced variability. The engine operation with high swirl was found to have significant improvement in cycle-to-cycle variations of both flow pattern and flow momentum.This paper is an extension of the previous work. Here, PIV measurements and flame imaging are applied to fired operation for studying how the swirl flow affects variability of ignition and subsequent combustion phases. PIV results for fired operation are consistent with the measurements made of motored flow. They demonstrate that the spark-plasma motion is highly correlated with the direction of the gas flow in the vicinity of the spark-plug gap. Without swirl, the plasma is randomly stretched towards either side of the spark plug, causing variability in the ignition of the two spray plumes that are straddling the spark plug. In contrast, swirl flow always convects the spark plasma towards one spray plume, causing a more repeatable ignition. The swirl decreases local RMS velocity, consistent with an observed reduction of early-burn variability. Broadband flame imaging demonstrates that with swirl, the flame consistently propagates in multiple directions to consume fuel-air mixtures within the piston bowl. In contrast, operation without swirl displays higher variability of flame-spread patterns, occasionally causing the appearance of partial-burn cycles. (C) 2016 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Experimental Investigation of the Variations of Early Flame Development in a Spark-Ignition Direct-Injection Optical Engine

An Experimental Investigation of Early Flame Development in an Optical Spark Ignition Engine Fueled with Natural Gas

Cycle-to-cycle Variation Analysis of Early Flame Propagation in Engine Cylinder Using Proper Orthogonal Decomposition

Cyclic Variations in a Lean-Burn Spark Ignition Engine Without and with Swirl

Experimental Investigation of the Flame Front Propagation Characteristic During Light-round Ignition in an Annular Combustor

Influence of Swirl Ratio on Fuel Distribution and Cyclic Variation under Flash Boiling Conditions in a Spark Ignition Direct Injection Gasoline Engine

Investigation of Swirl Ratio Impact on In-Cylinder Flow in an SIDI Optical Engine

Experimental Investigation of Low-Temperature Autoignition in Turbulent Premixed Swirling Flames

Influence of Flash Boiling and Swirl Ratio on the Gasoline Spray Structure in a Spark-Ignition Optical Engine: an Experimental Study

Computational Study of the Effect of Dual Air Swirling Injection on Turbulent Combustion of Kerosene–Air at a High Pressure

The Role of Spray-Enhanced Swirl Flow for Combustion Stabilization in A Stratified-Charge Disi Engine

Investigation of Cycle-To-Cycle Variation of In-Cylinder Engine Swirl Flow Fields Using Quadruple Proper Orthogonal Decomposition

Influence of Early and Late Fuel Injection on Air Flow Structure and Kinetic Energy in an Optical SIDI Engine

High-speed PIV, Spray, Combustion Luminosity, and Infrared Fuel-Vapor Imaging for Probing Tumble-Flow-induced Asymmetry of Gasoline Distribution in a Spray-Guided Stratified-Charge DISI Engine

Effect of Local Equivalent Ratio on Spark Ignition Characteristics in a Kerosene Scramjet Combustor at Mach 4 Flight Condition

Effects of flash boiling injection on in-cylinder spray, mixing and combustion of a spark-ignition direct-injection engine

Flame area correlations with heat release at early flame development of combustion process in a spark-ignition direct-injection engine using gasoline, ethanol and butanol

Experimental investigation of flow field features and spark ignition process in a multi-swirl airblast injector

Experimental Investigation of Dual-Swirl Spray Flame in a Fuel Staged Optical Model Combustor With Laser Diagnostics

The effects of injection pressure and swirl on in-cylinder flow pattern and combustion in a compression–ignition engine

An experimental study of the detailed flame transport in a SI engine using simultaneous dual-plane OH-LIF and stereoscopic PIV