Abstract:Rotating machines have a wide range of application involving shafts rotating at high speeds that must have high confidence levels of operation. Therefore, the dynamic behavior analysis of such rotating systems is required to establish operational patterns of the equipment, providing the basis for controller development in order to reduce vibrations or even to control oil instabilities in lubricated bearings. A classical technique applied in parameter identification of machines and structures is the modal analysis, which consists of applying a perturbation force into the system and then to measure its response. However, there are mainly two problems in modal analysis concerning the excitation of rotating systems. First, there are limitations to the excitation of systems with rotating shafts when using impact hammers or shakers, due to friction, undesired tangential forces, and noise that can be introduced in the system response. The second problem relies in the difficulty of exciting backward whirl modes, an inherent characteristic from these systems. Therefore, the study of a non-contact technique of external excitation, also capable of exciting backward whirl modes, becomes of high interest. In this sense, this article deals with the study and modeling of a magnetic actuator, used as an external excitation source for a rotating machine, mainly in backward whirl mode. Special attention is given to the actuator model and its interaction with the rotor system. Differently from previous works with similar proposal, which uses current and air gap measurements, here the external excitation force control is based on the magnetic field directly measured by hall sensor positioned in the pole center of the magnetic actuator core. The magnetic actuator design was completely developed for this purpose, opening different paths to experimental application of this device, for example, fault detection analysis based on directional modes. It is also presented a comparison between the numerical simulations and practical tests obtained from a rotor test rig and an experimental evidence of the backward whirl was accomplished based on the numerical simulation results.

Forward and Backward Mode Excitation of Flexible Rotor Supported by Tilting Pad Bearings - Numerical and Experimental Investigation

Investigation of Electromagnetic Forces Acting on Rotor Considering Modulation Effect of Surface-Mounted Pole Structure

Rotordynamic Evaluation of Full Scale Rotor on Tilting Pad Bearings with 0.1 and 0.3 Preload

Modeling a Two-Span Rotor System Based on the Hamilton Principle and Rotor Dynamic Behavior Analysis

ROTORDYNAMIC STABILITY EVALUATION WITH CONSTRUCTED FORWARD WHIRL SIGNALS BASED ON FULL SPECTRUM TECHNIQUE: NUMERICAL AND EXPERIMENTAL INVESTIGATION

An identification method for damping ratio in rotor systems

Harmonic and Fundamental Rotor Resistance Estimation Scheme for Multiphase Induction Motor Based on Nonsinusoidal Supply Control

Damping Ratio Identification in Rotordynamic System with Inverse Directional Fourier Transform, Multiple-Tests-multiple-outputs and Clustering Techniques

ANALYSIS OF THE MULTIPLE-SOLUTION RESPONSE OF A FLEXIBLE ROTOR SUPPORTED ON NON-LINEAR SQUEEZE FILM DAMPERS

Analysis of a complete model of rotating machinery excited by magnetic actuator system

On-line Unbalance Identification of Flexible Rotor System

Vibration Control of Base-Excited Rotors Supported by Active Magnetic Bearing Using a Model-Based Compensation Method

A Multifrequency Disturbances Identification and Suppression Method for the Self-Sensing AMB Rotor System

Identification of Bearing Dynamic Parameters and Unbalanced Forces in a Flexible Rotor System Supported by Oil-Film Bearings and Active Magnetic Devices

Experimental investigation for the dynamic mechanical properties of a vertical anisotropically supported rotor

Modal Characteristics Analysis of a Variable-Speed Pump-Turbine Rotor System: a Perspective of Resonance

Model and experimental analysis of a rotor rig dynamics with time-varying characteristics

Estimation of the Dynamic Parameters of the Bearings in a Flexible Rotor System Utilizing Electromagnetic Excitation by a Built-In Motor

Instability Region Classification and Control of Periodically Axially Loaded Rotor

Operational Modal Identification for Rotating Machinery under Environment Excitation

Theoretical analysis of a parametrically excited rotor system with electromechanically coupled boundary condition