Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

Dynamic Modeling And Validation Of The Boiler-Side Whole Process Of Subcritical Coal-Fired Power Plants

Online Performance Monitoring Platform Based on the Whole Process Models of Subcritical Coal-Fired Power Plants

Modeling Of The Coal-Fired Utility Boiler In A Thermal Power Plant Based On Macro Energy Balance

Dynamic Modeling for Utility Boiler Super-heater System and Simulation by Using Online Plant Data

Coal-fired power plant boiler combustion process modeling based on support vector machine and load data division

Modelica-based heating surface modelling and dynamic exergy analysis of 300 MW power plant boiler

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Dynamic performance analysis and control strategy optimization for supercritical coal-fired boiler: A dynamic simulation

Dynamic Modeling of Boiler Combustion System Based on Online Support Vector Machine

Closed-Loop Combustion Optimization Based on Dynamic and Adaptive Models with Application to a Coal-Fired Boiler

Nonlinear Dynamic Model of a 1 000 MW Once-through Boiler Unit and Its Closed Loop Validation

Dynamic Model for Subcritical Circulating Fluidized Bed Boiler-Turbine Units Operated in a Wide-Load Range

Optimizing Two-Phase Flow Heat Transfer: DCS Hybrid Modeling and Automation in Coal-Fired Power Plant Boilers

Dynamic Modelling, Validation And Analysis Of Coal- Fired Supercritical Once-Through Boiler-Turbine-Generator Systems Under Stringent Uk Grid Requirement

A Dynamic Mathematical Model of an Ultra-Supercritical Coal Fired Once-Through Boiler-Turbine Unit

Ash Fouling Monitoring Dynamic Models of Coal-Fired Utility Boiler's Heat Transfer Surface

Modeling and Simulation of the Long-term Dynamic Characteristics of a Supercritical Once-through Boiler

Dynamic simulation model for ultra supercritical 1 000 MW unit boilers

A dynamic mathematical model used for controller design of a supercritical once-through boiler-turbine unit in all load conditions

Dynamic Modeling and Simulation of CFB Boiler

Simulation on the Thermodynamic System of a 300 MW Coal-fired Power Plant