Abstract:Full power operation of the International Thermonuclear Experimental Reactor (ITER) has been delayed and will now begin in 2035. Delays to the ITER schedule may affect the availability of tritium for subsequent fusion devices, as the global CANDU-type fission reactor fleet begins to phase out over the coming decades. This study provides an up to date account of future tritium availability by incorporating recent uncertainties over the life extension of the global CANDU fleet, as well as considering the potential impact of tritium demand by other fusion efforts. Despite the delays, our projections suggest that CANDU tritium remains sufficient to support the full operation of ITER. However, whether there is tritium available for a DEMO reactor following ITER is largely uncertain, and is subject to numerous uncontrollable externalities. Further tritium demand may come from any number of private sector “compact fusion” start-ups which have emerged in recent years, all of which aim to accelerate the development of fusion energy. If the associated technical challenges can be overcome, compact fusion programmes have the opportunity to use tritium over the next two decades whilst it is readily available, and before full power DT operation on ITER starts in 2035. Assuming a similar level of performance is achievable, a compact fusion development programme, using smaller reactors operating at lower fusion power, would require smaller quantities of tritium than the ITER programme, leaving sufficient tritium available for multiple concepts to be developed concurrently. The development of concurrent fusion concepts increases the chances of success, as it spreads the risk of failure. Additionally, if full tritium breeding capability is not expected to be demonstrated in DEMO until after 2050, an opportunity exists for compact fusion programmes to incorporate tritium breeding technology in nearer-term devices. DD start-up, which avoids the need for external tritium for reactor start-up, is dependent upon full tritium breeding capability, and may be essential for large-scale commercial roll-out of fusion energy. As such, from the standpoint of availability and use of external tritium, a compact route to fusion energy may be more advantageous, as it avoids longer-term complications and uncertainties in the future supply of tritium.

Development of High Yield Low Level Tritium Targets for Inertial Fusion Reactor Systems

Development of High-Gain Reduced Tritium Targets for Inertial Fusion

Development of Advanced Fuel Inertial Fusion Targets

A Study of Energy Output from Implosion of A Reactor-Size Indirect Drive Reduced Tritium Inertial Fusion Target

Tritium Breeder Layer Evaluation of Fusion-Fission Hybrid System

Overview of Recent Tritium Target Filling, Layering, and Material Testing at Los Alamos National Laboratory in Support of Inertial Fusion Experiments

Optimization of tritium breeding and shielding analysis to plasma in ITER fusion reactor

Influence of DT Fuel Composition on the Energy Output and Its Implications on Reactor Safety and Environmental Acceptability

Optimization of Tritium Breeding Ratio in a DT and DD Submersion Tokamak Fusion Reactor

Tritium supply and use: a key issue for the development of nuclear fusion energy

Stable Deuterium-Tritium plasmas with improved confinement in the presence of energetic-ion instabilities

Physics of High Performance Deuterium-Tritium Plasmas in Tftr

Overview of Tritium-Resistant Performance of Heat Transfer Tube Materials in Reactors

Mechanism of Hydrogen Isotope Exchange for Tritium Removal in Plasma-Facing Materials: a Multi-Scale Investigation

Stable Deuterium-Tritium burning plasmas with improved confinement in the presence of energetic-ion instabilities

Fusion waste requirements for tritium control: Perspectives and current research

Preliminary assessment of high-entropy alloys for tritium storage

A Study of Tritium Seeded Advanced Fuel Targets

Confinement and Heating of a Deuterium-Tritium Plasma

TFTR DT Experiments

Use of tritium-rich fuel to improve the yield of layered deuterium/tritium inertial fusion capsules