Abstract:Volume holographic storage technology expands two-dimensional storage to multi-dimensional high-density storage, which can realize the advantages of large data storage capacity and fast data transmission speed. For holographic storage, material selection is very important. Photoinduced polymers are considered as one of the most promising holographic storage materials due to their high resolution, real-time recording and rapid preparation. Among them, phenquinone doped polymethyl methacrylate (PQ/PMMA) photoinduced polymer has negligible shrinkage rate, sensitivity to light polarization, anisotropy and other properties, and can be preserved for a long time, which is a good choice for holographic storage materials. However, due to the low solubility of PQ in methyl methacrylate (MMA), the diffraction efficiency and sensitivity of the material are still limited, which cannot meet the requirements of high speed writing of holographic stored data. In this paper, vinylpyrrolidone (NVP) monomer was introduced into PQ/PMMA photoinduced polymer system. Because PQ has better solubility in NVP, doping NVP monomer into the original system can increase the concentration of PQ from 1.0wt% to 1.2wt %. Compared with the basic PQ/PMMA materials with 1.0wt% PQ, the photosensitivity of the NVP-PQ/PMMA material are increased by 2 times (from 0.35 cm/J to 0.70 cm/J), and the diffraction efficiency are increased by 20%(from 57% to 77%). Finally, by using NVP-PQ/PMMA materials in collinear holography systems, holographic data storage can be achieved faster and with lower bit error rate than basic materials. In conclusion, the introduction of vinylpyrrolidone (NVP) monomer into PQ/PMMA photoinduced polymer system effectively improves the holographic properties of the material and has the potential to be an excellent holographic storage material.

Gold Nanosphere Doped Photopolymer for Volume Holography

Enhanced Diffraction Efficiency of Mixed Volume Gratings with Nanorod Dopants in Polymeric Nanocomposite

Improvement of Volume Holographic Performance by Plasmon-Induced Holographic Absorption Grating

Hybrid Polarization-Angle Multiplexing for Volume Holography in Gold Nanoparticle-Doped Photopolymer

Characteristics of gold nanorods in volume holographic nanocomposites

Improvements of Volume Holographic Grating in Photopolymer Doped with Nanorods (conference Presentation) (withdrawal Notice)

Plasmon-Active Mixed Gratings in Volume Holographic Polymeric Nanocomposites

Holographic Kinetics for Mixed Volume Gratings in Gold Nanoparticles Doped Photopolymer.

Epoxy Resin-Photopolymer Composite with None-Shrinkage for Volume Holography

A novel photopolymer material for holographic data storage

Volume holographic optical element for high-definition imaging

Synthesis of DMAW-PMMA Photopolymer with High Photosensitivity for Volume Holographic Storage

Highly Concentrated Phenanthraquinone-doped Co-Monomer Photopolymer for Holographic Data Storage

Highly sensitive and repeatable recording photopolymer for holographic data storage containing N-Methylpyrrolidone

Increasing the Concentration of Photosensitizer to Improve Holographic Properties of Photopolymer Materials

Photorefractive Zn:Fe:LiNbO 3 Crystal for Volume Holographic Storage Application

Recording Reflection Volume Holographic Gratings with Enhanced Performance by Two‐Stage Photopolymers Containing Bifunctional Monomers

Study on the Character of Novel Green Light Sensitive High-Density Digital Holographic Photopolymer

Three-dimensional Display Based on Refreshable Volume Holograms in Photochromic Diarylethene Polymer

Holographic Properties of PQ/PMMA Photopolymers with Different Thicknesses

Holographic Properties of Irgacure 784/PMMA Photopolymer Doped with SiO2 Nanoparticles