Abstract:The transformation-assisted consolidation under pressure has been demonstrated to be a promising method to fabricate the nano or submicron polycrystalline ceramic materials. The high pressure suppresses the long-range diffusion of the atoms and, consequently, restrains the grain coarsening. The new phases produced at high pressure could show finer grains under the appropriate thermodynamic conditions, which are not subject to the grain size of the raw materials. Ceramic materials exhibit the existence of the transformations under certain thermodynamic conditions and the formation of new phases generally undergoes the nucleation and growth. In the present work, monoclinic microcrystal ZrO2 with average grain size of 2 µm and Y2O3 with average grain size of 50 nm were mixed in molar ratio of 97∶3. The preparation of the samples was carried out by sintering at 5.5 GPa and temperatures of 800–1700 °C using the high pressure cubic cell, and the sample characterization was performed via the X-ray diffraction, scanning electron microscope and transmission electron microscopy. It was found that the monoclinic and submicron tetragonal composite polycrystalline ZrO2 in bulk is obtained under high pressure and high temperature. The average grain size of tetragonal ZrO2 fabricated at 1200, 1400, 1600 and 1700 °C is (145±62) nm, (246±165) nm, (183±62) nm and (245±107) nm, respectively. The synthesis of the fine-grained polycrystalline materials by the transformation under high pressure can solve the problems of agglomeration, adsorption and grain coarsening caused by the nanopowders as the starting materials in the conventional approach, which would be an alternative route to fabricate the fine-grained polycrystalline materials with the enhanced performances.

Enhancement of Yield Strength in Zirconium Metal Through High-Pressure Induced Structural Phase Transition

High Pressure Phase-Transformation Induced Texture Evolution and Strengthening in Zirconium Metal: Experiment and Modeling

Effects of Zr Addition on the Deformation Behavior, Microstructure and Mechanical Properties of Dental Ti Alloys

Strengthening Mechanism of Ω-Zr

Fabrication of Submicron Tetragonal Polycrystalline ZrO2 by the Transformation of Micro Monoclinic ZrO2 under High Pressure

Structural Phase Transitions and Metallization in Zirconium Disulfide (ZrS 2 ) under High Pressure

First-principles study on the structural stabilities, electronic and elastic properties for zirconium under pressure

Experimental Constraints on the Phase Diagram of Elemental Zirconium

Impurity Effects on the Phase Transformations and Equations of State of Zirconium Metals

Structural Phase Transitions and Metallization in Zirconium Disulfide (ZrS2) under High Pressure

Revisiting the High-Pressure Behaviors of Zirconium: Nonhydrostaticity Promoting the Phase Transitions and Absence of the Isostructural Phase Transition in β-Zirconium

Understanding phase stability and deformation mechanisms of zirconium under high pressures from generalized stacking fault energy curves: A first-principles study

First-principles investigations on elastic and thermodynamic properties of zirconium under pressure

Simultaneous Ultrasonic And Synchrotron X-Ray Studies On Pressure Induced Alpha-Omega Phase Transition In Zirconium

Phase relations and hardness trends of ZrO 2 phases at high pressure

The effect of zirconium on the microstructure and mechanical properties of a super-high-strength Al-Zn-Mg-Cu alloy

Enhanced Mechanical Properties and Oxidation Resistance of Zirconium Diboride Ceramics via Grain‐Refining and Dislocation Regulation

Influence of HPT and Accumulative High-Pressure Torsion on the Structure and Hv of a Zirconium Alloy

Effect of initial microstructure on its evolution and $α\rightarrow ω$ phase transition in Zr under hydrostatic loading

Thermal Equations of State of Theα,β, Andωphases of Zirconium

Transmission Electron Microscopy Observations of Structural Modulation in the Phase Transition from Α-Zr to Ω-Zr Induced by Shear Strain